CLAAS Id7730h / 7730h (157 04) – ENG (A15): Input voltage of the fuel pressure sensor in the common rail low.
Issue description
The input voltage of the fuel pressure sensor in the common rail is not functioning properly, typically registering an under-voltage when the signal drops below a 0.5V threshold. In response to this fault, the engine calculator (ENG A15) initiates protective measures by reducing engine power by 20% per minute until it reaches 50% of its nominal power. The system also manages the high-pressure pump to maintain 2000 bar of pressure in the common rail by opening the pressure restrictor.
Applies to these machines
18 machines- Axion 810
- Axion 820
- Axion 830
- Axion 840
- Axion 850
- Axion 960
- Arion 410
- Arion 420
- Arion 430
- Arion 510
- Arion 520
- Arion 530
- Arion 540
- Arion 610
- Arion 620
- Arion 630
- Arion 640
- Arion 650
Check the cause
Inspect the wiring harness connecting the fuel pressure sensor (designated as component B42 or B042) to the ENG (A15) module. Look for chafing, pinched wires, or a short circuit to ground.
Verify the power supply and output signal of the fuel pressure sensor. Check the connector pins for corrosion or poor contact.
Verify that the engine control module is outputting the correct 5V reference voltage to the sensor.
Repair steps
Safety First
Turn off the engine and allow the high-pressure fuel system to depressurize completely before loosening any fittings.
Locate the Sensor
Locate the fuel pressure sensor (B42) threaded into the common rail fuel distribution manifold.
Inspect Wiring
Disconnect the electrical connector from the sensor. Inspect the terminals. Use a multimeter to test the wiring harness back to the ENG (A15) module for continuity and ensure there is no short to ground.
Replace the Sensor
If the wiring harness and ECU reference voltage test good, the sensor itself has failed internally. Unthread the old B42 sensor from the common rail and install the replacement sensor. Torque to the manufacturer's specification.
Clear Codes
Reconnect the wiring harness, turn the key on, and use the CLAAS Diagnostic System to clear the Id7730h / 157 04 fault code.
Test Run
Start the engine and verify that the power reduction mode (50% derate) is deactivated and that fuel pressure readings are accurate in the diagnostic tool.
Parts you might need
(9)CLAAS OEM. The sensor threads directly into the common rail. Ensure the sealing surface is clean before installation.
Common Rail Fuel Pressure Sensor
0281006053Bosch OEM (Common Cross-Reference)
Common Rail Fuel Pressure Sensor
0281002937Bosch OEM (Common Cross-Reference)
Common Rail Fuel Pressure Sensor
0281002706Bosch OEM (Common Cross-Reference)
Common Rail Fuel Pressure Sensor (Holdwell)
11474490Aftermarket Option (specifically listed for Arion 410-640 series)
Common Rail Fuel Pressure Sensor (ENGITECH)
ENT260020Aftermarket Option
Fuel Rail Assembly (including pressure switch)
0011325930For CLAAS Arion/Axion. Bosch cross-reference: 0445226020
- Fuel Pressure Sensor6005019091
OEM part for CLAAS Arion 500 & 600 series
- Fuel Pressure Sensor6005033102
For various CLAAS Tractors and Combines
Get help to fix this fault by requesting a quote