7731h

CLAAS 7731h – Engine Control Module (ECM) / ENG (A15): Engine Cannot Start or Gain Power

Issue description

The engine is experiencing an issue that prevents it from starting or gaining power. This may be due to a problem within the affected circuit or the component identified by this code. The fault is likely logged by the Engine Control Module (ECM) or another controller limiting power for safety or to prevent damage.

Applies to these machines

  • Axion
  • Arion
  • Jaguar
  • Ares

Check the cause

  1. Access the diagnostic menu on the CEBIS terminal to view active and stored error codes, and monitor real-time parameters like fuel pressure, engine load, and coolant temperature

  2. Check for adequate fuel levels, ensure the fuel shutoff valve is open, and inspect for any signs of fuel contamination or gelling in cold weather

  3. Verify that the battery is fully charged and that all terminals and connections are clean and tight

  4. Inspect critical fuses and relays associated with the engine control and fuel systems

  5. Examine CAN bus network connectors for any signs of moisture ingress or corrosion

  6. Check the engine air filter for blockages and ensure the air intake path is clear

  7. Inspect the exhaust system, including SCR components, for potential blockages

  8. On machines with hydrostatic drives, check hydraulic oil levels and inspect filters for blockages

Repair steps

  1. Replace fuel filters

    Replace primary and secondary fuel filters. Clogged filters are a frequent cause of restricted fuel flow and subsequent power loss.

  2. Repair fuel lines

    Inspect all fuel lines for leaks, cracks, or loose connections. Repair or replace damaged lines to ensure proper fuel delivery.

  3. Address electrical faults

    Clean battery terminals, replace any blown fuses or faulty relays, and repair corroded CAN bus connectors to restore module communication.

  4. Clear intake and exhaust

    Replace blocked air filters and clear any restrictions in the exhaust or after-treatment (SCR) systems to reduce backpressure.

  5. Perform dealer diagnostics

    If initial checks do not resolve the issue, contact a certified CLAAS dealer for advanced diagnostics using the CLAAS Diagnostic System (CDS).

Parts you might need

(15)
  • Cross-reference with serial number

  • Fuel Filter

    21526170

    Cross-reference with serial number

  • For Arion/Axion

  • Fuel Filter

    19961531

    For Jaguar models

  • Fuel Filter

    KN70416

    For Jaguar models

  • For various models

  • Inline Fuel Filter

    6005701092

    For various models

  • Fuel Injection Pump

    0011318090

    For Arion 400-600 series

  • Fuel Injection Pump

    0011527620

    For Arion 400-600 series

  • Fuel Pump

    RE517230

    For various Ares, Arion, Axion models

  • Fuel Pump0011318210

    For various Ares, Arion, Axion models

  • Speed Sensor0006040150

    Cross-reference with serial number

  • RPM Sensor

    011810

    For Jaguar

  • Pressure Sensor6005033102

    Cross-reference with serial number

  • Cross-reference with serial number

Get help to fix this fault by requesting a quote

Browse other CLAAS codes