773Ah

CLAAS 773Ah – ENG: Cooled Exhaust Gas Temp Voltage Low

Issue description

The input voltage from the engine coolant temperature sensor is too high, which typically indicates an open circuit or a sensor failure. The Engine Control Unit (ECU) interprets this high voltage reading as an extremely low temperature. When this fault is active, the engine control module disregards the faulty signal and operates using a default (preset) coolant temperature value of 90°C.

Applies to these machines

  • Arion 410
  • Arion 430
  • Arion 510
  • Arion 530
  • Arion 550
  • Arion 610
  • Arion 620
  • Arion 640
  • Arion 650
  • Axion 810
  • Axion 850
  • Dominator

Check the cause

  1. Visually inspect the wiring harness and connectors for the Cooled Exhaust Gas Temperature Sensor (B221) and Engine Module (A15) for damage, corrosion, loose connections, or chafing.

  2. Check the sensor wiring for any short circuits to ground or other wires.

  3. With the ignition on and the sensor unplugged, use a multimeter to verify a steady 5V supply from the ECU at the wiring connector.

  4. Test the exhaust gas temperature sensor by disconnecting it, measuring resistance (Ohms) across its terminals, and applying heat to verify the resistance decreases continuously (verifying NTC sensor behavior).

  5. Check coolant level, coolant thermostat, and exhaust gas recycling cooler to rule out broader exhaust temperature issues.

Repair steps

  1. Confirm fault code

    Use a diagnostic tool to confirm that 773Ah is the active or stored fault code.

  2. Repair wiring or connectors

    If the visual inspection reveals damage, or if no 5V reference voltage is present at the sensor connector, repair the wiring harness between the sensor and the engine module.

  3. Replace temperature sensor

    If the wiring is intact and the ECU provides the correct 5V voltage, but the sensor fails the resistance test, replace the Cooled Exhaust Gas Temperature Sensor (B221). Ensure correct torque is applied during installation to prevent leaks.

  4. Replace engine module

    If the sensor and wiring are good but the fault persists or no 5V signal is generated by the module, replace the Engine Module (A15). Note: This requires programming or cloning by a certified technician.

  5. Clear codes and verify

    Clear all fault codes from the system and operate the machine to ensure the fault does not reappear.

Parts you might need

(6)
  • Cooled Exhaust Gas Temperature Sensor (B221)

    OEM CLAAS recommended. Multiple EGT sensors may be present; ensure the correct one in the cooled exhaust circuit is identified.

  • Engine Module (A15)

    001999652.0

    Part number is an example from one machine; verify exact part via CLAAS Parts Doc using serial number. Replacement requires programming.

  • Engine Coolant Temperature Sensor (B45)

    60712088
  • Engine Coolant Temperature Sensor (B45)

    679740
  • Engine Coolant Temperature Sensor (B45)

    6575680

Get help to fix this fault by requesting a quote

Browse other CLAAS codes