CLAAS 773Eh – ENG A15: Electronic Injector Short to Ground
Issue description
The engine control module has detected a short circuit to ground in the electrical circuit of an electronic fuel injector. This condition indicates that the electrical current intended for the injector is being diverted to the vehicle's chassis or another ground point instead of flowing through the injector's coil. As a result, the affected injector fails to deliver the correct amount of fuel, leading to incomplete combustion, engine misfiring, and the production of grey or black exhaust smoke.
Applies to these machines
5 machines- Axion 810
- Axion 820
- Axion 830
- Axion 840
- Axion 850
Check the cause
Identify the Components: Using a technical manual, locate the ENG A15 engine module, the engine wiring harness, and the electronic injectors (designated Y320-1, Y320-2, etc., in some Axion manuals).
Visually inspect the engine wiring harness for physical damage, chafing, melting, or corrosion, particularly where routed near hot engine components or sharp edges.
Inspect the electrical connectors at both the injectors and the ENG A15 engine module for corrosion, bent pins, or loose connections.
Perform an injector resistance test: disconnect the injector and measure resistance across its two pins, comparing the reading to manufacturer specifications or to other functioning injectors on the engine.
Perform an injector short-to-ground test: measure resistance from each injector pin to a clean, unpainted part of the engine block (chassis ground). A functional injector should show infinite resistance (open circuit).
Perform a wiring harness short-to-ground test: disconnect the harness from the suspect injector and the engine module, then check for continuity between each of the two injector wires and chassis ground at the module connector.
Repair steps
Prepare machine for service
Disconnect the battery and ensure the tractor is on level ground with the parking brake engaged before starting any repair work.
Isolate the fault
Perform the diagnostic checks listed above to confirm whether the fault lies with a specific injector or the wiring harness.
Replace faulty injector
If the injector short-to-ground test reveals internal continuity to ground, carefully clean the area around the injector, disconnect fuel lines, and remove mounting hardware. Install the new injector with correct seals and washers, then torque mounting bolts and fuel lines to manufacturer specifications.
Repair or replace wiring harness
If the harness test reveals a short to ground, trace the harness to locate the damaged section. Splice in a new section with sealed connectors if the damage is minor and accessible. Replace the entire engine wiring harness if the damage is extensive.
Reassemble and clear codes
Reconnect all electrical connectors and the battery. Use a diagnostic tool to clear the 773Eh fault code from the ENG A15 module's memory.
Verify repair
Start the engine and let it run to ensure the fault does not reappear. Check for any fuel leaks if injectors or fuel lines were replaced.
Parts you might need
(4)- Electronic Injector0011437690
OEM cross-reference for Axion 810 (alternate/aftermarket numbers include RE529118, RE531436, RE48786). Verify exact part by machine serial number.
Engine Wiring Harness
Must be ordered from a CLAAS dealer using the tractor's specific serial number.
Engine Injectors Wiring Loom
0011467660Part number is for Claas Arion 640; compatibility with Axion models is unconfirmed.
Engine Injectors Wiring Loom
0011505370Part number is for Claas Arion 640; compatibility with Axion models is unconfirmed.
Get help to fix this fault by requesting a quote