7747h

CLAAS 7747h – ECM: Crankshaft Intensity Issue

Issue description

The fault code indicates an issue related to the intensity of the crankshaft position sensor's signal, typically meaning the signal is too weak. The Engine Control Module (ECM) has detected an anomaly in the signal quality, which is critical for monitoring crankshaft speed and position for fuel injection and ignition timing.

Applies to these machines

  • Arion
  • Axion
  • Lexion
  • Jaguar

Check the cause

  1. Visually inspect the crankshaft position sensor and its wiring harness for physical damage, corrosion, or loose connections.

  2. Use a diagnostic scan tool to monitor the engine RPM while cranking; a reading of zero or an erratic signal indicates a sensor problem.

  3. Disconnect the sensor and check the wiring harness for continuity, shorts to ground, or shorts to power.

  4. Check for moisture intrusion into CAN bus connectors, which is a known issue on some CLAAS models that can cause erratic fault codes.

  5. Test the sensor with a multimeter: perform a resistance test (for inductive sensors) to check for open or short circuits, and a voltage test while cranking to verify signal output. For a Hall-effect sensor, check for a reference voltage (often 5V or 12V) and a ground connection with the key on, and then test the signal wire for a switching voltage while rotating the engine.

Repair steps

  1. Disconnect the battery

    Always disconnect the negative battery terminal before starting any electrical work.

  2. Locate and access the sensor

    Based on the specific machine model, locate the crankshaft position sensor. It may be necessary to remove other components for access.

  3. Disconnect the electrical connector

    Carefully release the locking tab and pull the connector off the sensor.

  4. Remove the sensor

    The sensor is typically held in place by one or two bolts. Remove the bolts and gently twist and pull the sensor out of its mounting hole.

  5. Install the new sensor

    Lightly lubricate the O-ring on the new sensor, if equipped, and insert it into the mounting hole. Ensure it is fully seated.

  6. Secure the new sensor

    Install and tighten the mounting bolt(s) to the manufacturer's specified torque. Over-tightening can damage the sensor.

  7. Reconnect the electrical connector

    Push the connector firmly onto the new sensor until it clicks into place.

  8. Reconnect the battery

    Reconnect the negative battery terminal.

  9. Clear fault codes

    Use a diagnostic tool to clear the fault code from the ECM's memory.

  10. Verify the repair

    Start the engine and check if the fault code returns. Monitor the engine RPM signal to ensure it is stable.

Parts you might need

(3)
  • Aftermarket replacement for CLAAS Combine Harvesters (also listed as 0117992)

  • Aftermarket replacement for CLAAS Combine Harvesters (also listed as 18219950 / 0118100.1)

  • Crankshaft Speed Sensor

    Generic part name. Verify correct OEM part number for specific machine model and serial number through an authorized dealer or Parts Doc.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes