Id77B7h / 77B7h (12)

CLAAS Id77B7h / 77B7h (12) – HYD (A60) - Hydraulic module: The "Configuration" message from valve 2 is not received or is improbable

Issue description

As a safety measure, electrodistributor 2 automatically returns to the neutral position.

Applies to these machines

  • Axion 800 series
  • Axion 810
  • Axion 820
  • Axion 830
  • Axion 840
  • Axion 850

Check the cause

  1. Check the Hydraulic CAN Bus communication network for faults

  2. Check the connectors and continuity of the harnesses linking the HYD (A60) module to the electrodistributor module (A105-2)

  3. Test the wiring for any short-circuits or open circuits

  4. Check the sources of energy, including fuses, power supply voltage, and ground connections to the modules

  5. Inspect the hydraulic module HYD (A60) and the electrodistributor module (A105-2) for physical damage, mechanical seizing, or temperature issues

  6. Check the compatibility of the program versions, settings, and calibration of the hydraulic modules

Repair steps

  1. Analyze Codes

    Note all error codes present on the tractor. Analyze the interaction between them to ensure Id77B7h wasn't generated by a broader CAN bus failure (such as a BDG module communication error).

  2. Test the Circuit

    Using a multimeter, perform continuity and voltage drop tests on the Hydraulic CAN bus lines between the HYD (A60) module and the electrodistributor module (A105-2).

  3. Repair Wiring

    If a short, open circuit, or corroded connector pin is found, repair or replace the affected harness section.

  4. Replace the Valve

    If the wiring, power, and ground are all within specification, the internal electronics of the electrodistributor module (A105-2) have likely failed and the valve must be replaced.

  5. Calibrate

    If a new electrodistributor is installed, perform the necessary software calibration so the HYD (A60) module recognizes the new valve's configuration.

  6. Clear and Test

    Clear all error codes from the system, then operate the tractor's hydraulic functions to verify the anomaly does not return.

Parts you might need

(2)
  • Electrodistributor module (A105-2) / Hydraulic Lift Valve / Spool Valve Element

    00 1164 149 0

    Specify that you need "Valve 2" (Component A105-2) for the rear remote stack. Ensure the replacement valve is properly calibrated to the tractor's CAN bus network upon installation.

  • Electrodistributor module (A105-2) / Hydraulic Lift Valve / Spool Valve Element

    00 1164 150 0

    Specify that you need "Valve 2" (Component A105-2) for the rear remote stack. Ensure the replacement valve is properly calibrated to the tractor's CAN bus network upon installation.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes