Id77EEh / 77EE (32)

CLAAS Id77EEh / 77EE (32) – HYD (A60): Power supply of valve 4 is too high (> 36 V)

Issue description

Power supply of valve 4 is too high (> 36 V). The specific component flagged by the system is the electrodistributor module (A105-4).

Applies to these machines

  • Axion 800 series
  • Axion 810
  • Axion 850

Check the cause

  1. Identify the Origin: Note all error codes present on the tractor and analyze their interaction, as one error code can generate another.

  2. Component Check: Inspect the electrodistributor module (A105-4).

  3. Wiring and Harnesses: Check the connectors and the continuity of the harnesses linking the HYD (A60) module to the electrodistributor module (A105-4).

  4. Voltage and Shorts: Check for any short-circuits (especially a short to a high-voltage power source, given the >36V reading) or open circuits.

  5. Power Sources: Check the sources of energy, including fuses, power supply lines, and ground connections.

  6. Component Resistance: Check the internal resistance of the electrodistributor module if required.

Repair steps

  1. Power Down

    Turn off the tractor and disconnect the negative battery cable before servicing the electrical system.

  2. Inspect Wiring

    Trace the wiring harness from the HYD (A60) ECU to the valve 4 electrodistributor (A105-4). Look for chafed wires that may be shorting to a higher voltage source.

  3. Test Voltage

    Reconnect the battery, turn the ignition on, and use a multimeter to test the supply voltage at the valve 4 connector. Verify if the voltage is actually exceeding 36V or if the module is reading it incorrectly.

  4. Repair Harness

    If a short-circuit to power is found in the harness, repair or replace the damaged wiring section.

  5. Replace Valve

    If the wiring, ground, and supply voltages are correct but the fault persists (indicating an internal failure in the valve's circuitry), replace the electrodistributor module (A105-4).

  6. Clear and Retest

    Clear all error codes from the system, then operate the tractor to ensure the anomaly does not appear again.

Parts you might need

(5)
  • Hydraulic Valve

    0011500450

    Fits Axion 800/900 series

  • Hydraulic Valve

    0011739740

    12V, 2/2-way valve

  • Directional control valve

    0011464380
  • Directional control valve

    0011375800
  • Hydraulic lift valve

    0011369690

    Manufactured by Bosch Rexroth, OEM Ref: R917005640

Get help to fix this fault by requesting a quote

Browse other CLAAS codes