CLAAS Id78A1h / 78A1h – EXT (A62): CSM sequence interrupted as ignition off

The CSM (CLAAS Sequence Management) sequence was actively running or paused when the operator turned the tractor's ignition off, causing the sequence to abort.

• Axion 800 Series
• Axion 810
• Axion 850
• Axion 900 Series
• Axion 920
• Axion 950

1. 1

   Verify Operator Action: Confirm with the operator if the tractor was shut down while a headland management sequence was active.

2. 2

   Cycle the Ignition: Turn the tractor on and check if the code moves from 'Active' to 'Stored/Inactive'.

3. 3

   Test CSM Functionality: Drive the tractor above 1.5 km/h (minimum speed required) and attempt to record/play a new sequence to ensure the EXT module is operating normally.

1. 1

   Turn on ignition

   Turn the ignition back on.

2. 2

   Access CSM menu

   Navigate to the CSM (CLAAS Sequence Management) menu on the CEBIS display.

3. 3

   Clear sequence

   Clear the interrupted sequence.

4. 4

   Verify code clearance

   The error code will clear itself from the active faults list.