78B5h

CLAAS 78B5h – TR2 (A57-2): Automatic Gear Shifting Sequence Stopped

Issue description

The automatic gear shifting system (HEXACTIVE) has become disconnected during a shifting sequence, which may prevent proper gear changes and affect the operation of the tractor. This typically occurs when the transmission control module (TCU) receives conflicting or implausible signals from the transmission's sensors during an automated shift, resulting in a failure to engage a gear or a timeout in the shifting operation.

Applies to these machines

  • Arion 500
  • Arion 600
  • Arion 640-510
  • Axion 800
  • Axion 810
  • Axion 830
  • Axion 850

Check the cause

  1. Check for other active or stored fault codes that may pinpoint the root cause (e.g., specific sensor or solenoid codes)

  2. Inspect connectors and wiring harnesses linked to the TR2 (A57-2) module for damage, corrosion, or moisture ingress (especially in CAN bus connectors)

  3. Check the power supply for short or open circuits, ensuring the module has stable power and a good ground connection

  4. Inspect all relevant transmission system fuses

  5. Test transmission sensors (speed and range position) and the three ON/OFF solenoid valves for correct operation

  6. For HEXASHIFT transmissions, listen for a crunching sound when shifting from D to C range, which indicates a potential C-range bearing failure

Repair steps

  1. Retrieve All Fault Codes

    Use the tractor's diagnostic system to check for any other active or stored fault codes. This can provide valuable context. For example, other codes related to specific sensors or solenoids can help narrow down the problem.

  2. Perform General Electrical Checks

    Systematically inspect all wiring and connectors associated with the transmission control system.

  3. Inspect HEXASHIFT Transmission

    If the tractor is equipped with a HEXASHIFT transmission, be aware of the potential for C-range bearing failure. Listen for any unusual noises during range changes.

  4. Test Sensors and Solenoids

    If specific sensors or solenoids are suspected based on other fault codes or symptoms, they should be tested for correct operation.

  5. Re-launch the Sequence

    As the fault description suggests, it may be possible to resolve the issue by re-launching the automatic gear shifting sequence. This may involve cycling the power to the tractor or using the operator interface to re-engage the automatic shifting mode.

  6. Component Replacement

    If a specific component, such as a sensor, solenoid, or the TR2 (A57-2) module itself, is identified as faulty, it should be replaced.

Parts you might need

(6)
  • TR2 (A57-2) Transmission Control Module

    2019878

    Verify correct part number with a CLAAS dealer using the tractor's serial number.

  • General CLAAS Module

    0143331

    Alternate module part number seen in diagnostics.

  • General CLAAS Module

    0143332

    Alternate module part number seen in diagnostics.

  • HEXASHIFT C-range bearing

    Order through a CLAAS parts dealer if mechanical failure is identified.

  • Alternative OEM numbers: 6005026047, 11326120, 0505261. Located on the transmission to detect shift rail position. Verify correct part number for specific tractor model and serial number.

  • Transmission Control Module (TCU)

    A057-1

    Alternative OEM number: 7700049277D. Controls transmission shifting functions. Repair services are available.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes