CLAAS 78BAh: TR3 (A57-3) Rear power take-off disconnected during a sequence CSM
Issue description
The TR3 (A57-3) Rear power take-off is disconnected during a sequence CSM, causing the power take-off to be inoperative. After 20 seconds, the tractor initializes and the sequence is relaunched. If no action is taken, the CSM should be reset.
Check the cause
The status of the TR3 (A57-3) Rear power take-off during sequence CSM
The functionality of the CSM after 20 seconds of initialization
The condition of the power take-off system following the sequence
Repair steps
Verify the status of the TR3 (A57-3) Rear power take-off during sequence CSM
Ensure that the power take-off is properly engaged and connected during the sequence.
Monitor the CSM after 20 seconds
Check if the CSM initializes correctly and the sequence is relaunched.
Reset the CSM if the sequence does not proceed as expected
Follow the manufacturer's procedure to reset the CSM and re-initiate the sequence.
Parts you might need
(0)Get help to fix this fault by requesting a quote
