CLAAS Id78DBh / 78DBh – EXT (A62): The CSM sequence is interrupted.

The CLAAS Sequence Management (CSM) sequence is interrupted because it is attempting to use an "unknown function". This is typically a software, memory, or configuration issue where a previously recorded headland management sequence contains a command that the tractor's system no longer recognizes, or an implement was changed without updating the sequence.

• Axion 810
• Axion 830
• Axion 850
• Axion 870
• Axion 920
• Axion 930
• Axion 940
• Axion 950
• Arion 510
• Arion 530
• Arion 550
• Arion 610
• Arion 630
• Arion 640
• Arion 650
• Arion 660

1. 1

   Review CSM sequences on the CEBIS display for any functions tied to implements or optional equipment that are currently disconnected or disabled.

2. 2

   Verify that the tractor is set to the correct implement profile (CSM allows up to 20 implements to be stored).

3. 3

   Check the compatibility of the program versions, settings, and calibrations for the EXT module.

1. 1

   Clear the Sequence

   Navigate to the CSM settings in the CEBIS terminal.

2. 2

   Edit or Delete

   Delete the specific sequence that is causing the interruption, or edit it to remove the unrecognized function.

3. 3

   Re-record the Sequence

   Perform a new time- or distance-related recording of the headland management sequence, ensuring you only activate functions that are currently supported and recognized by the tractor's configuration.

4. 4

   Test Operation

   Activate the sequence using the CMOTION or F buttons to ensure it completes without interruption.

5. 5

   CDS Update

   If the tractor continues to flag functions as "unknown" despite being properly equipped, a dealer will need to connect the CLAAS Diagnostic System (CDS) to perform a software update or re-flash the EXT (A62) module.