7F2Fh

CLAAS 7F2Fh – CEBIS, Implement Controller, or EFA: Real Speed Sensor (Radar) Not Connected

Issue description

This fault code indicates a communication failure or a complete lack of signal from the ground speed radar sensor. The sensor provides accurate, real-time ground speed data independent of wheel slip, which is essential for automatic header and reel speed adjustments, application rate control, area and yield calculations, and guidance systems. The underlying condition is likely a break in the electrical circuit between the sensor and the control module, a faulty sensor, or a power supply issue.

Applies to these machines

  • LEXION
  • TRION
  • JAGUAR
  • AXION
  • XERION

Check the cause

  1. Check the radar sensor for physical damage and ensure the face is clean and unobstructed by mud, debris, or moisture

  2. Inspect the mounting bracket to ensure the sensor is secure and at the correct angle to the ground

  3. Trace the wiring harness from the sensor to the main loom, looking for cuts, abrasions, or corrosion

  4. Disconnect the sensor and check the harness connector for 12V power and a good ground connection

  5. Inspect the connector pins for corrosion or damage

  6. Perform a continuity test on the signal wire between the sensor connector and the corresponding pin at the control module

  7. Navigate to the diagnostics or sensor information page on the machine's terminal to see if the system is registering any signal from the radar

  8. Perform a self-test or diagnostic function for the radar sensor if the system supports it

Repair steps

  1. Confirm the fault

    Ensure the fault code is active and not an intermittent or old code.

  2. Perform diagnostics

    Complete the diagnostic checks listed above to rule out simple issues like a dirty sensor or a loose connection.

  3. Address wiring issues

    If any wiring faults are found, repair or replace the damaged section of the harness.

  4. Replace the sensor

    If the wiring is intact and the sensor is receiving power but not outputting a signal, the sensor itself is likely faulty and should be replaced.

  5. Calibrate the system

    After replacing the sensor, perform a calibration through the machine's control terminal (e.g., CEBIS). This typically involves driving a measured distance or performing a stationary learning procedure to ensure accurate speed readings.

Parts you might need

(1)
  • Generic CLAAS speed sensor part number. Verify correct part number for specific machine model and serial number through CLAAS Parts Doc.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes