7F2Fh

CLAAS 7F2Fh – DBD (A101): Real Speed Sensor (Radar) Not Connected

Issue description

The real speed sensor (radar unit) used for the tractor's anti-slip control system is not communicating with the DBD (A101) instrument panel control module. This connection failure causes the tractor to deactivate the anti-slip control feature and revert to its normal operating mode. The system will restore anti-slip functionality once the connection issue is resolved.

Applies to these machines

  • CLAAS Arion 640-510 Series
  • CLAAS Axion 800 Series

Check the cause

  1. Visually inspect the B230 radar sensor (typically located at the front or rear of the chassis, pointing towards the ground) for physical damage to the housing or lens.

  2. Disconnect the B230 electrical connector and inspect pins and terminals for corrosion, dirt, or damage.

  3. Inspect the wiring harness leading to the sensor for cuts, abrasions, or pinch points.

  4. Use a multimeter to verify the sensor is receiving the correct voltage and has a solid ground connection at the connector.

  5. Check the continuity of the wiring harness between the B230 sensor connector and the A101 Instrument Panel Module connector to rule out an open circuit.

  6. Perform a diagnostic check of the Powertrain CAN bus and the CLAAS vehicle CAN bus network, as communication issues here can also trigger this fault.

Repair steps

  1. Repair wiring or connectors

    If the fault is due to a damaged connector or wiring, repair or replace the affected section of the harness. Ensure all connections are clean and secure.

  2. Replace radar sensor

    If diagnostic checks confirm that the B230 sensor itself is faulty, replace the sensor unit.

  3. Calibrate new sensor

    After replacing the radar sensor, use a diagnostic tool to initiate the calibration process while the tractor is on a flat, level surface. This ensures the sensor is correctly aligned with the vehicle's geometry.

  4. Clear fault codes

    Use a diagnostic tool to clear the 7F2Fh fault code from the A101 Instrument Panel Module's memory.

  5. Verify operation

    Operate the tractor and check the functionality of the anti-slip control system to confirm that the repair has been successful.

Parts you might need

(3)
  • Real Speed Sensor (Radar) (B230)

    0155350

    General CLAAS speed sensor part number. Direct applicability unconfirmed; verify via CLAAS Parts Doc using machine serial number.

  • General CLAAS speed sensor part number. Direct applicability unconfirmed; verify via CLAAS Parts Doc using machine serial number.

  • Related part number for various Arion models. Verify correct part number with an authorized CLAAS dealer using the tractor's serial number before ordering.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes