7F30h

CLAAS 7F30h – DBD (A101): Rear PTO Speed Sensor Disconnected

Issue description

The DBD (A101) control module has lost the signal from the rear PTO speed sensor (B142), which is responsible for monitoring the rotational speed of the rear PTO shaft. This disconnection causes the tractor to enter a fault condition. The system is designed to return to normal operation once the sensor is properly reconnected and the signal is restored.

Applies to these machines

  • Arion 640-510 series
  • Axion 800 series

Check the cause

  1. Attempt to clear the fault code first to determine if the issue is an intermittent signal loss

  2. Visually inspect the rear PTO speed sensor (B142) and its wiring harness for frayed wires, loose connections, or corrosion

  3. Check connector and harness continuity between the B142 sensor and the control module for open circuits or short circuits

  4. Verify the sensor is receiving the correct voltage and has a solid ground connection (check associated fuses)

  5. Inspect the sensor adjustment to ensure the correct air gap exists between the sensor and the target gear

Repair steps

  1. Ensure Safety

    Disconnect the tractor's battery to prevent electrical shorts during the repair.

  2. Locate the Sensor

    The rear PTO speed sensor (B142) is typically mounted on the rear transmission or PTO housing, positioned over the internal PTO drive gear.

  3. Access and Inspect

    Gain access to the sensor, which may require removing protective covers or other components.

  4. Repair Wiring

    If the diagnostic checks reveal a wiring issue, repair or replace the damaged section of the harness. Ensure all connections are clean and secure.

  5. Replace Sensor

    If the sensor itself is determined to be faulty, unbolt it from the housing and disconnect the electrical connector. Install the new sensor, ensuring it is seated correctly.

  6. Set Air Gap

    If adjustable, set the proper air gap between the sensor tip and the gear teeth according to the manufacturer's specifications. This is a critical step for proper operation.

  7. Reassemble

    Reinstall any components that were removed to gain access to the sensor.

  8. Reconnect and Test

    Reconnect the battery, start the tractor, and check if the fault code has cleared. Engage the PTO to verify that the speed is being registered correctly by the system.

Parts you might need

(4)
  • Rear PTO Speed Sensor

    000676835

    Inductive magnetic sensor. Alternate part numbers: 6768350, 676835. Verify compatibility with specific tractor model and year.

  • Inductive magnetic sensor. Alternate part numbers: 011810.0, 1821995. Verify compatibility with specific tractor model and year.

  • Inductive magnetic sensor. Verify compatibility with specific tractor model and year.

  • Inductive magnetic sensor. Alternate part numbers: 011810.1. Verify compatibility with specific tractor model and year.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes