CLAAS A006h: Spool behaviour error for 1 valve

The 1 valve spool is not reaching the requested position and is returning to neutral. This indicates a discrepancy between the expected and actual position of the 1 valve spool.

1. 1

   Check the operation of the 1 valve spool

2. 2

   Verify the signal being sent to the 1 valve spool

3. 3

   Inspect for any mechanical interference affecting the 1 valve spool

1. 1

   Clear the error

   Follow the procedure to clear the fault code as specified in the service manual.

2. 2

   Monitor the system

   Observe the operation of the 1 valve spool after clearing the error to determine if the issue persists.

3. 3

   Replace the 1 valve

   If the error reappears, replace the 1 valve as indicated in the source.