CLAAS A01Bh: Timeout without commanding the 1 valve

The system has detected a timeout where the 1 valve has not been commanded for a certain period. As a result, the 1 valve is in the neutral position.

1. 1

   The command signal to the 1 valve

2. 2

   The timing or logic of the control system

3. 3

   The status of the 1 valve

1. 1

   Verify the command signal to the 1 valve

   Check if the control system is sending the correct command signal to the 1 valve.

2. 2

   Inspect the timing or logic of the control system

   Review the timing or logic settings in the control system to ensure they are functioning as intended.

3. 3

   Confirm the status of the 1 valve

   Check the current status of the 1 valve to ensure it is responding correctly to commands.