A041h

CLAAS A041h – Main hydraulic or transmission control unit: Fault in Valve 2

Issue description

Valve 2 within the tractor's hydraulic system has failed to reach the float position within the designated timeframe, causing the valve to revert to a neutral position. This malfunction is frequently caused by high hydraulic oil viscosity due to cold temperatures impeding the valve's movement, though it can also stem from electrical solenoid faults or internal mechanical binding.

Applies to these machines

  • Arion 500
  • Arion 600
  • Axion
  • Ares
  • Xerion
  • COMMANDER 115 CS

Check the cause

  1. Warm up the hydraulic oil to normal operating temperature to see if the fault clears (checks for cold temperature/high viscosity issues)

  2. Check hydraulic fluid level, condition, and verify it is the correct type specified by CLAAS

  3. Inspect electrical connections and wiring to the Valve 2 solenoid for damage, corrosion, loose connections, short circuits to ground, short circuits between cables, or open circuits

  4. Attempt to actuate the valve and observe its physical movement to check for sticking or incomplete travel

Repair steps

  1. Confirm fault code

    Use a diagnostic tool to confirm that the A041h fault is active or logged in the ECU.

  2. Warm up hydraulic system

    If operating in cold temperatures, run the tractor to bring the hydraulic system to normal operating temperature. If the fault clears, the issue was likely high oil viscosity and no further repair is needed.

  3. Test solenoid

    If the fault persists after warming up, test the valve's solenoid for proper electrical resistance and activation to rule out an electrical failure.

  4. Inspect valve internals

    If the solenoid functions correctly, remove the valve and inspect for a sticking/binding spool, contamination, worn seals, or broken internal components.

  5. Clean or replace valve

    Clean the valve body and reassemble with new seals, or replace the entire valve assembly if internal components are damaged.

  6. Clear codes and test

    Reinstall the valve, clear the fault codes from the ECU, and test the hydraulic system to ensure proper operation.

Parts you might need

(4)
  • Verify fitment by serial number

  • Spool valve assembly (Ares and Axion)

    6005028082

    Verify fitment by serial number

  • Spool valve assembly (Ares and Axion)

    6005027572

    Verify fitment by serial number

  • Mechanical Auxiliary Spool Valve / Solenoid Valve

    Generic part name, exact part depends on machine serial number

Get help to fix this fault by requesting a quote

Browse other CLAAS codes