CLAAS A043h: Fault in Valve 2 Position

The 2 valve is not in the desired position. The valve spool was pushed too far, causing an error. The error can be cleared, but if it reoccurs, the 2 valve may need to be replaced.

1. 1

   The position of the 2 valve

2. 2

   The operation of the valve spool

3. 3

   The presence of recurring error after clearing

1. 1

   Clear the error

   Follow the procedure to clear the error as specified in the service manual.

2. 2

   Monitor for recurrence

   Observe if the error reappears after clearing.

3. 3

   Replace the 2 valve

   If the error reoccurs, replace the 2 valve as indicated in the source.