CLAAS A108h: Spool behaviour error for 7 valve

The 7 valve spool is experiencing a behaviour error, where the position requested does not match the controlled position. The 7 valve returns to neutral, and the error can be cleared. If the error reoccurs, the 7 valve may need to be replaced.

1. 1

   The operation of the 7 valve spool

2. 2

   The position feedback mechanism for the 7 valve

3. 3

   The system's ability to maintain the requested position of the 7 valve

1. 1

   Clear the error

   Use the diagnostic tool to clear the A108h fault code.

2. 2

   Monitor the system

   Observe the operation of the 7 valve after clearing the error to determine if the issue persists.

3. 3

   Replace the 7 valve

   If the error reappears, replace the 7 valve as indicated in the source.