A112h

CLAAS A112h – HYD (A60): Supply of 7 Valve Above Max

Issue description

The control module has detected a voltage in the electrical supply circuit for valve 7 (front electrohydraulic control valve) that exceeds the manufacturer's specified maximum limit. This indicates an electrical fault, such as a short circuit to a positive voltage source, faulty wiring, or an internal failure within the associated electronic control unit, which can lead to malfunction or damage to the solenoid coil.

Applies to these machines

  • Arion 640-510 series
  • Axion 850

Check the cause

  1. Check alternator and battery voltage for an overcharging condition using a multimeter

  2. Inspect the electrical system, including wiring, connections, and CAN bus connectors, for faults, looseness, or moisture

  3. Clear the fault code and operate the machine to see if the error reappears

  4. Monitor the system and hydraulic valve status via the CEBIS terminal

Repair steps

  1. Verify system voltage

    With the machine running, measure the voltage at the battery and from the alternator output terminal. If the voltage is excessively high (generally above 14.8V on a 12V system, or 29.6V on a 24V system, though specifications may vary), the alternator or its voltage regulator is likely faulty and should be addressed first.

  2. Inspect wiring harness

    If the voltage is normal, inspect the wiring harness and connectors between the HYD (A60) controller and the number 7 hydraulic valve for any signs of damage, corrosion, or loose connections.

  3. Clear code and test

    Clear the A112h fault code using the appropriate diagnostic tool or via the machine's terminal. Operate the tractor and the hydraulic functions to see if the code returns.

  4. Replace the hydraulic valve

    If the charging system voltage is correct and the fault code reappears after being cleared, the internal electronics of the "7 valve" are likely damaged. In this case, the recommended solution is to replace the valve.

Parts you might need

(3)
  • No. 7 Hydraulic Valve

    Contact a CLAAS dealer with the machine's serial number to source the correct component.

  • Hydraulic block

    631322.2

    Referenced for CLAAS Lexion combines; verify fitment for your specific machine.

  • Referenced for CLAAS Lexion combines; verify fitment for your specific machine.

Get help to fix this fault by requesting a quote

Browse other CLAAS codes