CLAAS A11Dh: Timeout without commanding the 7 valve

The system has detected a timeout where the 7 valve has not been commanded for a certain period. As a result, the 7 valve is in the neutral position.

1. 1

   The command signal to the 7 valve

2. 2

   The timing or logic of the control system

3. 3

   The status of the 7 valve

1. 1

   Verify the command signal to the 7 valve

   Check if the control system is sending the correct command signal to the 7 valve.

2. 2

   Inspect the timing or logic of the control system

   Review the timing or logic settings that govern when the 7 valve should be commanded.

3. 3

   Confirm the status of the 7 valve

   Ensure the 7 valve is physically in the neutral position as described.