CLAAS A145h: Fault Code A145h - The 8 Valve is not at the position The valve spool was pushed too far

The 8 valve is not in the position it is supposed to be in. The valve spool was pushed too far, causing an error. The error can be cleared, but if it reoccurs, the 8 valve may need to be replaced.

1. 1

   The position of the 8 valve

2. 2

   Whether the valve spool has been pushed too far

3. 3

   Whether the error can be cleared

1. 1

   Clear the error

   Follow the procedure to clear the error as described in the service manual.

2. 2

   Check the 8 valve position

   Verify that the 8 valve is in the correct position as required.

3. 3

   Check the valve spool

   Inspect the valve spool to ensure it has not been pushed too far.

4. 4

   Replace the 8 valve if necessary

   If the error reappears after clearing, replace the 8 valve.