E-64

CLAAS E-64 – CIS: AUTOCONTOUR Module (CAC) Failure

Issue description

The fault code E-64 indicates a failure within the AUTOCONTOUR (CAC) module, a component of the CLAAS Information System (CIS). This module is responsible for the automatic control of the header's height and its ability to follow ground contours. A failure in this module disrupts these functions, potentially leading to improper header positioning, erratic movements, or a complete loss of automatic height control.

Applies to these machines

  • Jaguar
  • Lexion 480R
  • Lexion 540R
  • Lexion 550
  • Lexion 560
  • Lexion 560R
  • Lexion 570
  • Lexion 570R
  • Lexion 575R
  • Lexion 580
  • Lexion 580R
  • Lexion 585R
  • Lexion 590
  • Lexion 590R
  • Lexion 595R

Check the cause

  1. Perform a system reset by power cycling the machine to resolve potential temporary electronic glitches

  2. Examine the AUTOCONTOUR module's wiring harness for chafing, corrosion, or loose connections

  3. Check the electrical connectors at the module for moisture ingress, which can cause short circuits

  4. Verify that the AUTOCONTOUR module is receiving the correct voltage and has a solid ground connection

  5. Inspect the sensors associated with the AUTOCONTOUR system, particularly the potentiometers on the header and feeler plates, for physical damage or blockages

  6. Check the sensor readings to ensure they are within the specified range

  7. Ensure the machine's software is up to date, as older versions may have known calibration issues

Repair steps

  1. Repair wiring and connectors

    Address any damaged wiring or clean corroded connectors found during the visual inspection. Ensure all connections are secure.

  2. Test and replace sensors

    If sensor readings are out of specification or if the header is behaving erratically, test the relevant potentiometers. Replace any faulty sensors.

  3. Perform system calibration

    After replacing sensors or if the system is not tracking correctly, perform a full AUTOCONTOUR system calibration as per the machine's operator or service manual. Ensure the machine's software is up to date.

  4. Replace AUTOCONTOUR module

    If all other diagnostic steps fail to resolve the E-64 code and the issue persists, the AUTOCONTOUR (Cac) module itself is likely faulty and should be replaced.

Parts you might need

(8)
  • Autocontour Module (cac)

    00151921

    For Lexion 590

  • Autocontour Module (cac)

    0139930

    For Lexion 480R

  • Autocontour Module (cac)

    0146434

    For Lexion 540R, 560, 560R, 570, 570R, 575R, 580R, 585R, 590R, 595R

  • Autocontour Module (cac)

    0146433

    For Lexion 540R, 560, 560R, 570, 570R, 575R, 580R, 585R, 590R, 595R

  • Autocontour Module (cac)

    0160550

    For Lexion 550, 580

  • Autocontour Module (cac)

    016055.0

    For Lexion 550, 580

  • For Lexion 550, 580

  • For Lexion 550, 580

Get help to fix this fault by requesting a quote

Browse other CLAAS codes