Deutz-Fahr 105 – ECU: Charge Air Temperature Above Target Range
Issue description
The engine's charge air temperature has exceeded a predefined critical limit. The charge air temperature sensor detects this condition and signals the Engine Control Unit (ECU). In response, the system triggers a fault and initiates a protective reaction, typically reducing engine power and speed to prevent damage. This fault is also associated with SPN 105, FMI 0, and SERDIA ID IATSCDSysReac.
Applies to these machines
9 machines- Deutz-Fahr tractors
- Deutz TCD 2.9 L4
- Deutz TCD 3.6 L4
- Deutz TCD 4.1 L4
- Deutz TCD 6.1 L6
- Deutz TCD 7.8 L6
- Deutz 1013
- Deutz 2012
- Deutz 2013
Check the cause
Check for external factors such as high ambient temperatures and dusty operating conditions
Inspect the cooling system: ensure radiator and charge air cooler fins are clean, check cooling fan operation, verify fan belt tension/condition, and check coolant level
Inspect the charge air system for restrictions or blockages in the charge air cooler, and check hoses/connections for leaks
Inspect the air filter for clogs, which can lead to higher exhaust temperatures and reduced performance
Visually inspect the charge air temperature sensor and its wiring for damage, corrosion, or loose connections
Test the sensor's resistance using a multimeter to ensure it changes appropriately with temperature
Repair steps
Locate the sensor
Find the charge air temperature sensor, typically located in the air intake boot, air cleaner housing, or intake manifold (or cylinder head on air-cooled models).
Disconnect battery
Disconnect the negative battery cable for safety before starting work.
Disconnect wiring
Carefully disconnect the electrical connector from the sensor.
Remove old sensor
Remove the sensor from its mounting, whether held by a clip or threaded into the intake.
Install new sensor
Install the new sensor, ensuring it is properly seated. If threaded, tighten to the manufacturer's specified torque.
Reconnect the Electrical Connector
Attach the electrical connector to the new sensor, ensuring it clicks into place.
Reconnect the Battery
Reconnect the negative battery cable.
Clear Fault Codes
Use a diagnostic tool to clear the fault code from the ECU's memory.
Test the System
Start the engine and let it run to verify that the fault code does not reappear.
Parts you might need
(5)- Charge Air Temperature Sensor04210196
Replaces 4213839. Used in Deutz 1013, 2012, 2013, TCD 2.9/3.6/4.1/6.1/7.8 L4/L6 engines.
Charge Air Temperature Sensor
04212750Replaces 04210898. Used in Deutz TD 2.9 L4 and TCD 3.6 L4 engines.
- Charge Air Temperature Sensor04216425
Used in Deutz TCD 3.6 engines.
- Charge Air Temperature Sensor04216354
Used in Deutz TCD 3.6 L4 engines.
- Charge Air Temperature Sensor04213839
Used in Deutz TCD 2012 engines.
Get help to fix this fault by requesting a quote