1084

Deutz-Fahr 1084 – ECM: SCR Main Relay Battery Short Circuit

Issue description

A short circuit to the battery has been detected in the power supply circuit controlled by the SCR system's main relay (secondary side). This indicates an electrical fault where the wiring on the secondary (output) side of the relay is shorted to a positive voltage source.

Applies to these machines

  • TCD 3.6
  • TCD 4.1
  • TCD 6.1
  • TCD 7.8

Check the cause

  1. Verify the fault code using a diagnostic tool like Deutz SerDia to confirm the exact definition (SPN 4366 and FMI 5) for your specific engine.

  2. Visually inspect the wiring harness and connectors associated with the SCR system's main relay for melted insulation, corrosion, or loose connections.

  3. With the ignition on, use a multimeter to check for battery voltage at the relay's secondary side output terminal. A constant voltage reading when the relay should be off confirms a short to the battery.

  4. Isolate the circuit by disconnecting components powered by the SCR main relay one by one to see if the short circuit condition disappears.

Repair steps

  1. Disconnect power

    Disconnect the vehicle's battery before starting any electrical repairs to ensure safety.

  2. Locate the SCR main relay

    Find the SCR main relay, typically located in a fuse and relay box in the engine bay or cab. Use a machine-specific wiring diagram to pinpoint its exact location.

  3. Test the relay

    Remove the relay and check the coil resistance between pins 85 and 86 (should be 50-120 ohms). Verify there is no continuity between pins 30 and 87 when de-energized. Apply 12V to pins 85 and 86; the relay should click and show continuity between pins 30 and 87.

  4. Inspect relay socket

    Check the relay socket for damage or corrosion. If the relay tests good, the fault is likely in the wiring.

  5. Trace the faulty wire

    Trace the wire from the secondary side of the relay to the components it powers. Look for points where the wire's insulation may have rubbed through and is contacting a power source or another wire.

  6. Repair or replace wiring

    Repair the damaged section of the wire using appropriate connectors and heat shrink for a sealed repair. If the damage is extensive, replace the affected harness section.

  7. Reassemble and test

    Reconnect the battery, clear the fault codes using a diagnostic tool, and start the engine to verify that the fault does not return.

Parts you might need

(4)
  • Deutz Relay04216031

    Fits various TCD engines

  • Built to OEM specifications

  • Deutz Relay01340791

    Generic Deutz relay

  • Bosch Relay

    0 332 002 150

    Heavy-duty upgrade for Deutz main relay

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes