Deutz-Fahr 110 – ECU: Outside Target Range with System Reaction
Issue description
The Engine Control Unit (ECU) has detected a coolant temperature reading that is either higher or lower than the expected operational range, or the signal from the sensor is implausible. This triggers a system reaction, which could include activating a warning lamp, initiating an engine derate to prevent damage, or defaulting to a substitute value. In the absence of more specific codes, this fault can sometimes point to a general communication or electrical error on the CAN bus network caused by a weak battery or poor connections.
Applies to these machines
3 machines- Agrotron K90
- Agrotron K110
- Agrotron 110 MK3
Check the cause
Check for any other active fault codes, as code 110 can sometimes be a symptom of a broader electrical issue
Ensure the battery is fully charged and that all battery and ground connections are clean, tight, and free of corrosion (a weak battery can trigger spurious codes)
Inspect the wiring harness for the coolant temperature sensor for chafing, breaks, perished insulation, or short circuits to the battery (+Ubatt) or ground
Unplug the connector at the coolant temperature sensor and check for corrosion, moisture, or damaged/loose pins
Analyze the FMI code if available: FMI 0/1 indicates actual overheating/overcooling, FMI 2 indicates an erratic signal, FMI 3 indicates a short to power, and FMI 4 indicates a short to ground
Repair steps
Perform initial electrical checks
Address preliminary diagnostic checks, including verifying battery voltage and inspecting the wiring harness and connectors for obvious damage. Clean connectors with electrical contact cleaner and apply dielectric grease.
Clear faults and re-evaluate
Clear the fault codes and operate the machine. If the fault code does not return, the issue was likely related to a poor connection or temporary condition.
Test coolant temperature sensor
If the fault persists, measure the sensor's resistance at different temperatures and compare it to the manufacturer's specifications. Alternatively, check the voltage signal at the ECU connector.
Repair wiring or replace sensor
If the wiring is found to be damaged, repair or replace the affected section of the harness. If the sensor provides incorrect readings or has internal shorts/opens, replace the sensor.
Final verification
After replacing any components, clear the fault codes again and run the machine to ensure the repair has been successful and the code does not reappear.
Parts you might need
(4)Engine Coolant Water Temperature Sensor
01182703Cross-references to 04194047. Verify compatibility with specific engine model and serial number.
Verify compatibility with specific engine model and serial number.
Verify compatibility with specific engine model and serial number.
Cross-references to 04199809. Verify compatibility with specific engine model and serial number.
Get help to fix this fault by requesting a quote