1174

Deutz-Fahr 1174 – ECM: Engine Electric Fuel Transfer Pump 1 - Voltage Above Normal Value or Short Circuit to Plus

Issue description

The Engine Control Module (ECM) has detected an abnormally high voltage or a short circuit to a positive power source in the electrical circuit of the electric fuel transfer pump. This condition affects the proper operation of the fuel transfer pump, which can lead to system malfunctions such as poor engine performance, difficult starting, or a complete failure to start.

Applies to these machines

  • Deutz TCD 2012
  • Deutz TCD 2013
  • Deutz TCD 2.9L (Tier 4)
  • Deutz TD 2.2 L3

Check the cause

  1. Check the fuel pump circuit breaker (often labeled CB3) to see if it has tripped, and inspect terminals for loose connections, corrosion, or signs of burning.

  2. Inspect fuel lines running from the pump to the engine for any kinks, pinches, or restrictions that could cause the pump to overwork and draw excessive current.

  3. Verify power and a solid ground connection at the fuel pump's electrical connector using a multimeter (with emergency stops engaged and the key in the ON position).

  4. Inspect the fuel pump relay in the main fuse/relay box. Check for power to the relay's coil and verify the ground signal from the ECU.

  5. Carefully wiggle the engine wiring harness, particularly sections connected to the fuel pump and ECM, to check for intermittent loose connections or internal breaks. Pay close attention to the ECM connector for any loose or corroded pins.

  6. Measure the resistance between the signal and return pins of the disconnected fuel pump to check for internal failure.

  7. Measure the resistance of the wiring harness between the ECM connector and the fuel pump connector to check for open circuits or shorts to ground.

Repair steps

  1. Isolate and de-energize

    Turn off the vehicle ignition and disconnect the battery to prevent electrical shorts before beginning repairs.

  2. Access components

    Based on the diagnostic findings, access the faulty component, which could be the fuel pump, relay, or a section of the wiring harness. The electric fuel pump is often mounted near the fuel tank.

  3. Repair or replace wiring

    If a short circuit or open circuit is found in the wiring harness, repair the damaged section with OEM-grade connectors and wire, ensuring all connections are sealed against moisture. Replace the harness section if damage is extensive.

  4. Replace fuel pump relay

    If power and ground are present at the relay's control circuit but there is no output to the pump, remove the faulty relay from the fuse box and install a new one with the same part number.

  5. Replace electric fuel transfer pump

    If the pump itself is confirmed faulty, disconnect the fuel lines and electrical connector. Unbolt the old pump and install the new one, ensuring all seals and O-rings are correctly seated. Reconnect lines and wiring.

  6. Final system check

    Reconnect the battery. Turn the ignition to the ON position (without starting) and listen for the fuel pump to prime (audible hum). Clear the fault code using a diagnostic tool, start the engine, and verify normal operation.

Parts you might need

(3)
  • OEM Deutz part. Alternate numbers: 04514751, 04294706, 04507514, 04290596. Compatible with TCD2012, TCD2013, FL1013, and FL2012 engines.

  • Fuel Pump Relay

    Varies by machine model. Typically Bosch or Tyco. Check the specific machine's parts catalog or the number on the original relay.

  • Fuel Pump Circuit Breaker

    Varies by machine model and electrical system design.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes