Deutz-Fahr 1175 – ECU: Fuel Transfer Pump Voltage Low or Shorted
Issue description
The Engine Control Unit (ECU) has detected that the voltage in the electrical circuit for the fuel transfer pump is below the normal operating range or has shorted to ground. This impairs the pump's ability to deliver fuel from the tank to the high-pressure system, which can cause low power, poor running, or a complete failure to start. The ECU disables the fuel pump actuator driver to protect the circuit when excessive current is detected.
Applies to these machines
6 machines- Series 5
- Series 5D
- Series 5DF
- Series 5K
- Series 5TB
- Series 4E
Check the cause
Inspect the fuel pump electrical connector for corrosion, moisture ingress, dirt, or damaged/bent pins.
Examine the wiring harness from the ECU to the fuel transfer pump for physical damage such as chafing, pinching, melting, or breaks in the insulation.
Check for a short to ground by disconnecting the harness and measuring resistance between the pump's power supply wire and chassis ground (a reading under 100 kΩ indicates a short).
Test for voltage supply with the ignition ON (engine off) by measuring voltage between the power supply pin and chassis ground; it should be close to battery voltage.
Test the fuel pump internal circuit by measuring resistance across its pins to check for an internal short (extremely low reading) or open circuit (infinitely high reading).
Check the ECU functionality as a last resort using a diagnostic tool (like Deutz SerDia) to command the pump ON, verifying the ECU driver circuit has not failed.
Repair steps
Repair wiring or connectors
If diagnostic checks reveal damage, repair or replace the affected sections of the wiring harness or connectors. Ensure all connections are clean and secure.
Replace fuel transfer pump
If the pump has an internal short or open circuit, disconnect the negative battery terminal, relieve fuel pressure, and replace the pump. Ensure gaskets or seals are correctly fitted.
Prime fuel system
After replacing the pump or opening fuel lines, thoroughly prime the system to remove all air before attempting to start the engine.
Clear codes and verify
Use a diagnostic scanner to clear fault code 1175 from the ECU memory. Start the engine, check for fuel leaks, and re-scan to ensure the issue is resolved.
Parts you might need
(1)- Electric Fuel Transfer Pump04297075
OEM Deutz part for TCD 2012/2013 engines. Verify fitment against specific machine serial number.
Get help to fix this fault by requesting a quote