Deutz-Fahr 118: Speedo Signal Missing
Issue description
The system has detected a loss of the speed signal. This points to a potential problem with the component responsible for generating or transmitting the vehicle's speed information.
Applies to these machines
3 machines- Agrotron 108
- Agrotron 118
- Agrotron 128
Check the cause
Use an electronic service tool to read all active fault codes to determine if other sensors sharing the same wiring harness are also malfunctioning
Inspect the speed sensor cabling for short circuits or breaks
Inspect the speed sensor connectors for dirt, debris, or moisture and clean them if necessary
Consult the specific workshop manual for your model for detailed diagnostic procedures and safety precautions
Repair steps
Read fault codes
Use a service tool to check for other active codes that might indicate a shared harness issue.
Inspect and repair wiring
Check the speed sensor wiring and connectors for breaks, shorts, dirt, or moisture. Repair or replace any damaged wiring or clean connectors as needed.
Replace speed sensor
If the wiring and connectors are intact, the speed sensor is the most likely cause. Replace the speed sensor with the correct OEM part for your specific model.
Clear codes and test
Clear the fault code using the service tool and test the vehicle to ensure the speed signal is restored and the issue is resolved.
Parts you might need
(8)- Speed Sensor01182834
Genuine OEM Deutz part for heavy equipment
- Speed Sensor4210197
Compatible with Deutz TCD 3.6 L4, TCD7.8L6, TD2.9L4, 2015, and 2013 engines
- SPEED SENSOR0.900.0923.0
SAME DEUTZ FAHR (SDF) part
- SPEED SENSOR04364426
DEUTZ-FAHR part
- Transmission Speed Sensor L= 94mm0.900.7759.3
Fits some Deutz-Fahr and SAME tractors.
Fits some Deutz-Fahr and SAME tractors.
Transmission Speed Sensor L= 94mm
0501.337.900Fits some Deutz-Fahr and SAME tractors.
Transmission Speed Sensor L= 94mm
0501337900Fits some Deutz-Fahr and SAME tractors.
Get help to fix this fault by requesting a quote