Deutz-Fahr 1431 – ECU: PROEGRActr CAN Message Implausible
Issue description
The Engine Control Unit (ECU) is receiving data from the Exhaust Gas Recirculation (EGR) actuator over the CAN bus, but the values within the data message are outside of the expected or logical range. This plausibility error indicates an issue with the communication data integrity or an internal malfunction within the EGR actuator causing it to send corrupt data.
Applies to these machines
2 machines- Models with Deutz TD 2.9 L4 engines
- Models with Deutz engines equipped with the EMR4 control system
Check the cause
Visually inspect the wiring harness and connectors between the Engine ECU and the EGR actuator for signs of damage, chafing, corrosion, pinched wires, or loose connections.
Scan for other active or stored fault codes. Code 1432 (Timeout Error) often appears with 1431, and SPN 639 could indicate a wider CAN bus network issue.
Perform a CAN bus integrity test with the battery disconnected. Measure resistance between CAN High and CAN Low (a healthy bus reads ~60 ohms; 120 ohms indicates an open circuit/missing resistor; significantly lower indicates a short circuit).
With the ignition on, check voltages on the CAN lines (CAN High should be 2.5-3.5V, CAN Low 1.5-2.5V) and check for shorts to power or ground.
Locate the EGR actuator (PROEGRActr) on the engine block connected to the EGR cooler to verify physical condition.
Repair steps
Repair Wiring Issues
If any wiring faults were found during the diagnostic checks, repair or replace the damaged sections of the harness. Ensure all connectors are clean, secure, and free of corrosion. After repairs, clear the fault codes and re-test.
Isolate the Component
If the CAN bus wiring tests as good, the fault likely lies within the EGR actuator itself. The actuator may have an internal electronic failure causing it to send implausible data.
Component Replacement
If the EGR actuator is identified as the faulty component, it must be replaced (often integrated with the EGR valve as a single unit). After replacement, perform a learning or calibration procedure using a diagnostic tool like Deutz SerDia or Jaltest to ensure the new component is recognized and functions correctly with the ECU.
ECU Reset
After any repair, clear the fault codes from the ECU's memory and perform a full ignition cycle to see if the fault returns.
Parts you might need
(3)- EGR Control Valve4134412
Listed as a Control Valve for TCD 2.9 engines. Verify fitment with engine serial number.
- EGR Module4133060
Listed for Deutz D/TD/TCD 2.9 L4 series engines. Verify fitment with engine serial number.
- EGR Valve4120412
Listed for Deutz D/TD/TCD 2.9 L4 series engines. Verify fitment with engine serial number.
Get help to fix this fault by requesting a quote