Deutz-Fahr 1535: Cable Break in NOx Sensor Before SCR Catalyst

A fault has been detected in the cable of the NOx sensor located before the SCR catalyst. This issue may affect the proper functioning of the emissions control system.

1. 1

   Cable connection at the NOx sensor

2. 2

   Cable integrity between the NOx sensor and the controller

3. 3

   Wiring harness for damage or breaks

1. 1

   Inspect

   Visually inspect the cable at the NOx sensor for any signs of damage or disconnection.

2. 2

   Test

   Use a multimeter to test the continuity of the cable between the NOx sensor and the controller.

3. 3

   Replace

   If a break is found, replace the damaged section of the cable or the entire cable as needed.