Deutz-Fahr 1678 – ECM: EGR Actuator CAN Communication Timeout
Issue description
The Engine Control Module (ECM) has detected a timeout in the reception of the CAN message 'ComRxEGRMsFlw2' from the EGR actuator. This indicates that the expected communication message was not received within the designated timeframe, which may affect the proper operation of the related system. This is a communication fault and does not necessarily indicate a mechanical failure of the EGR actuator itself.
Applies to these machines
5 machines- TCD 2.9
- TCD 3.6
- TCD 4.1
- TCD 6.1
- TCD 7.8
Check the cause
Visually inspect the wiring harness and connectors between the ECM and the EGR actuator for signs of damage, chafing, corrosion, pinched wires, or loose connector pins.
Check CAN bus termination by measuring resistance across the CAN High and CAN Low pins with the system powered off (a healthy bus should read approximately 60 Ohms).
Measure CAN bus DC voltages with the ignition on and engine off (CAN High should be 2.5-3.5 V, CAN Low should be 1.5-2.5 V).
Isolate the fault by disconnecting one CAN bus device at a time, starting with the EGR actuator, and re-measuring resistance and voltages to see if the bus returns to normal.
Repair steps
Verify wiring and network
Perform all diagnostic checks to ensure the CAN bus wiring and network are intact. Do not proceed with component replacement unless the wiring is verified as healthy.
Repair wiring issues
If any wiring faults are found during diagnostics, repair or replace the damaged section of the harness. Ensure all connectors are clean, secure, and free of corrosion.
Test the EGR actuator
If wiring is good, disconnect the EGR actuator and measure resistance between its CAN pins (very low resistance indicates an internal short). Use a diagnostic tool like Deutz SerDia to perform an active test of the actuator.
Replace the EGR actuator
If all other diagnostic steps fail to resolve the issue and the actuator's internal electronics are preventing communication, replace the EGR actuator with a new part.
Clear codes and verify
Use a diagnostic tool to clear fault code 1678 from the ECM's memory. Start the engine and let it run to confirm that the fault code does not reappear.
Parts you might need
(7)EGR Actuator / Valve
04218605Fits TCD4.1L4, TCD6.1L6, TCD7.8L6. Alternate part number 04507015. Verify with engine serial number.
EGR Actuator / Valve
D4510627Fits TCD 4.1 L4. Alternate part number 4510627.
- EGR Actuator / Valve4120412
Fits TCD 2.9 / 3.6 L4.
12V EGR Valve
04121508Verify with engine serial number.
Verify with engine serial number.
EGR Module
04133060Verify with engine serial number.
- EGR Shuttle/Reed Valve04257888
Part of the EGR system. Alternate part numbers: 04265310, 04515377, 04125434.
Get help to fix this fault by requesting a quote