1680

Deutz-Fahr 1680 – ECU: CAN Timeout: Exhaust Throttle Valve Actuator

Issue description

The Engine Control Unit (ECU) has detected a timeout in the reception of the CAN message 'Com Rx ETVActr'. This indicates that the expected communication signal from the Exhaust Throttle Valve Actuator (ETV) was not received within the allowed time frame. This represents a communication break on the CAN bus rather than an internal mechanical failure of the component, which can negatively impact exhaust gas flow regulation and DPF regeneration cycles.

Applies to these machines

  • 5 Series

Check the cause

  1. Visually inspect the wiring harness and connectors between the Engine ECU and the Exhaust Throttle Valve Actuator for chafing, corrosion, pinched wires, or loose connections

  2. Disconnect and inspect the pins and sockets at both the ETV actuator and ECU connectors for moisture, corrosion, and secure fitment

  3. Perform a CAN bus health check: with the ignition off, measure resistance between CAN High and CAN Low pins (should be approximately 60 Ohms. 120 Ohms indicates a break or missing terminating resistor; near 0 Ohms indicates a short circuit)

  4. Verify the ETV actuator is receiving the correct voltage and has a solid ground connection according to the machine's wiring diagram

Repair steps

  1. Isolate the Faulty Component

    If the wiring and network checks do not reveal an issue, the fault may lie with the ETV actuator itself or, less commonly, the ECU.

  2. Wiring Repair

    If any wiring faults are found, repair or replace the damaged section of the harness. Ensure all connections are secure and protected from environmental factors.

  3. Component Replacement

    If the wiring is confirmed to be intact and the fault persists, the Exhaust Throttle Valve Actuator is the most likely cause of the failure. Replace the actuator.

  4. ECU Reset and Verification

    After performing repairs, clear the fault codes from the ECU memory using a diagnostic tool. Start the engine and run the machine to verify that the fault code does not reappear.

Parts you might need

(1)
  • Part number is for a similar Deutz actuator and provided for reference only. ETV actuators are highly specific to the engine model; verify the correct OEM part via the tractor's serial number.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes