Deutz-Fahr 1681 – ECU: CAN Timeout: Intake Throttle Valve Actuator
Issue description
The Engine Control Unit (EMR4) has detected a timeout in the reception of the CAN message 'Com Rx ITVActr' from the intake throttle valve actuator. This indicates that the expected communication is not being received within the allowed timeframe, preventing the ECU from determining the throttle valve position or controlling it, which can lead to engine speed control issues.
Check the cause
Visually inspect the wiring harness and connectors between the EMR4 ECU and the electronic throttle valve actuator for chafing, corrosion, pinched wires, or loose connections.
Perform a CAN bus termination resistor check with power off: measure resistance between CAN_H and CAN_L (should be approximately 60 Ohms). A reading of 120 Ohms indicates a missing resistor or open circuit; below 60 Ohms indicates a short or faulty ECU.
Check for CAN bus shorts to ground with power off: measure resistance between CAN_H to ground and CAN_L to ground (should be open circuit/mega-ohms).
Check for CAN bus shorts to power with ignition on: measure DC voltage between CAN_H to ground (expected 2.5-3.0V) and CAN_L to ground (expected 2.0-2.5V).
Repair steps
Repair wiring and connectors
Address any issues found during diagnostic checks. Repair or replace damaged sections of the wiring harness and clean or securely seat loose or corroded connectors.
Replace throttle valve actuator
If wiring and network resistance are correct, the fault likely lies with the throttle valve actuator. Replace the actuator.
Test and replace ECU
If a new throttle valve does not resolve the issue, the EMR4 ECU may be at fault. This requires specialized diagnostic tools from a dealer to confirm before replacement.
Clear fault codes
After repairs, clear the fault codes from the ECU's memory and operate the machine to verify the fault does not return.
Parts you might need
(4)Referenced for Deutz TCD2011, DL2011, FL2011 engines. Verify fitment by serial number.
Verify fitment by serial number.
Electronic Throttle Valve Actuator
04281525Referenced for Deutz 1011F and 2011 engines in JLG equipment. Verify fitment by serial number.
Electronic Throttle Valve Actuator
04271979Referenced for Deutz 1011F and 2011 engines in JLG equipment. Verify fitment by serial number.
Get help to fix this fault by requesting a quote