175

Deutz-Fahr 175 – ECU: Below Target Range with System Reaction / Oil Temperature issue

Issue description

The engine control module (ECU) has detected an implausible or out-of-range signal from the engine oil temperature sensor. Depending on the specific Failure Mode Identifier (FMI), this indicates either that the engine oil temperature has exceeded the normal operating range (triggering a high-temperature warning to protect the engine from decreased oil viscosity) or that there is an unspecific electrical error within the oil temperature monitoring circuit.

Applies to these machines

  • 1011
  • 2011
  • 914
  • TCD 3.6
  • TCD 2012
  • TCD 2015

Check the cause

  1. Verify engine oil level and condition to ensure it is within the correct operating range

  2. Inspect the engine's oil cooler for blockages from dirt or debris that could restrict airflow and reduce cooling efficiency

  3. Visually inspect the oil temperature sensor, connector, and wiring harness for loose connections, corrosion, water damage, chafing, melting, or oil leaks

  4. Check for approximately 5 volts supply voltage at the harness-side connector with the ignition on (engine off)

  5. Test the sensor's electrical resistance cold and hot to ensure the resistance drops significantly as temperature increases (e.g., ~37,000 ohms at 20°C to ~2,800 ohms at 90°C)

Repair steps

  1. Address preliminary findings

    If diagnostic checks reveal low oil, a blocked oil cooler, or damaged wiring, rectify these issues first before replacing components.

  2. Replace the oil temperature sensor

    If resistance testing confirms a faulty sensor, unscrew the old sensor from the oil filter housing or oil pan, clean the sealing surface, and install the new sensor to the manufacturer's specified torque.

  3. Clear fault codes

    Reconnect the sensor and battery. Use a diagnostic tool to clear the fault codes from the ECU memory.

  4. Verify the repair

    Start the engine and let it run. Monitor the oil temperature parameter with a diagnostic scanner to ensure the fault code does not reappear.

Parts you might need

(6)
  • Oil Temperature Sensor

    01179305

    Fits Deutz 1011 and 2011 series engines.

  • Oil Temperature Sensor

    01182377

    Fits Deutz 1011 and 2011 series engines.

  • Fits Deutz F6L914, BF4M1011F, and TCD914L06 engines.

  • Fits various 2011 series engines (e.g., BF4M2011, D2011L04I, TCD2011L04W).

  • Oil Temperature Sensor

    04213210

    Fits various water-cooled and air-cooled Deutz engines, including TCD2012, 2013, and 914 series.

  • Fits various water-cooled and air-cooled Deutz engines, including TCD2012, 2013, and 914 series.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes