Deutz-Fahr 1759 – ECU: Low Voltage Supply to AGR Steller
Issue description
The engine control system has detected that the voltage supply to the EGR actuator (AGR Steller) is below the required minimum threshold. A low voltage supply prevents the actuator from accurately positioning the EGR valve, leading to incorrect exhaust gas recirculation flow rates. This condition can negatively affect engine performance, fuel economy, and emissions.
Applies to these machines
4 machines- 4E Series
- 5D Series
- 5G Series
- 6 Series Agrotron
Check the cause
Check for other active fault codes, particularly those related to general low battery voltage (e.g., SPN 520296/FMI 3), as a systemic electrical issue must be addressed first
Inspect the wiring harness and electrical connector at the EGR actuator for chafing, corrosion, bent or spread pins, loose connections, or fluid contamination
With the ignition on and engine off, measure the voltage between the power and ground pins at the EGR actuator's electrical connector (should be greater than 11 volts)
If voltage is low, measure between the power pin and a known good chassis ground to determine if the fault is in the power supply wire or the ground circuit
With the ignition off, measure the resistance of the actuator's internal circuits
Repair steps
Address preliminary faults
Diagnose and repair any general low voltage codes before proceeding with EGR-specific repairs.
Repair wiring or connectors
If inspection reveals damaged wiring or connectors, repair or replace the affected parts. Ensure all connections are clean and secure.
Replace the EGR Actuator/Valve
If wiring, connectors, and voltage supply are confirmed good, replace the EGR actuator. In many designs, this is integrated with the EGR valve and replaced as a single assembly.
Clear fault codes
After replacing the component, clear the fault codes from the ECU using a compatible diagnostic tool like Deutz SerDia.
Perform calibration/relearn
Perform a calibration or relearn procedure with a diagnostic tool so the ECU recognizes the new component and its position range.
Verify the repair
Start the engine and operate the machine under normal load to ensure the fault code does not reappear.
Parts you might need
(4)- EGR Valve / Actuator Assembly0.019.7395.0/20
Fits Deutz-Fahr 4E, 5D, 5G, and 6 Series. Also listed as 00197395020.
Listed as a control valve/EGR cooler module for Deutz engines.
EGR Valve
DTZ04102108Compatible with 04102108 and 04102833.
- EGR Module4133060
General EGR module for Deutz engines.
Get help to fix this fault by requesting a quote