Deutz-Fahr 190 – ECU: Engine Running with Cam-shaft Speed Signal Only
Issue description
The Engine Control Module (ECU) has lost the primary signal from the crankshaft speed sensor or deemed it unreliable. To prevent a complete engine shutdown, the ECU enters a backup or limp-home mode, using only the camshaft speed sensor signal to continue operation, typically with reduced performance. This may also indicate an issue with proper synchronization between the crankshaft and camshaft signals.
Applies to these machines
8 machines- TCD 2012
- TCD 2013
- TCD 2015
- TCD 2.9
- TCD 3.6
- TCD 4.1
- TCD 6.1
- TCD 7.8
Check the cause
Inspect the wiring harness and connectors for both the crankshaft and camshaft speed sensors for chafing, corrosion, loose pins, or heat damage
Perform a 'wiggle test' on the crankshaft sensor wiring harness while the engine is running or while monitoring sensor output to identify intermittent breaks
Check the crankshaft speed sensor mounting and verify the air gap between the sensor and the sensor wheel meets manufacturer specifications
Examine the sensor wheel (tone ring) for bent, broken, or missing teeth, as well as incorrect installation or misalignment
Check for electrical interference by ensuring high-power cables are not routed too close to the sensor wiring
Repair steps
Confirm fault code
Use a diagnostic tool to confirm that fault code 190 (or corresponding Deutz codes 75, 77, or 78) is active.
Repair wiring and connectors
If any damage to the wiring harness or connectors is found during inspection, repair or replace the affected section and ensure all connections are clean and secure.
Correct alignment and air gap
Adjust the sensor wheel alignment and sensor air gap to proper specifications. Replace the sensor wheel if it is damaged.
Replace crankshaft speed sensor
If the wiring and sensor wheel are in good condition, replace the crankshaft speed sensor with a new OEM or equivalent part, as this is the most likely cause.
Replace camshaft speed sensor
If the issue persists after replacing the crankshaft sensor, or if dealing with a phase-shift error (code 78), test and replace the camshaft speed sensor.
Clear codes and verify
Clear the fault codes from the ECU memory using a diagnostic tool. Start the engine and let it run to confirm the fault does not reappear.
Parts you might need
(4)- Crankshaft Position/Speed Sensor04214103
Specifically for TCD2012
- Crankshaft Position/Speed Sensor04199447
Fits TCD 2012, TCD 2013, TCD 2015
- Crankshaft/Cam Sensor4213840
Fits TCD 2013, 2015, TD3.6, TD2.9
- Camshaft Position/Speed Sensor04210924
Fits TCD2012 and TCD2013
Get help to fix this fault by requesting a quote