223

Deutz-Fahr 223 – Engine ECU: TSC 1 Message Counter Error

Issue description

This fault code has two distinct interpretations depending on the engine ECU. On MD1 ECUs (logged as SPN 4206 FMI 2), it indicates the TSC 1 (Torque/Speed Control 1) Message Counter is reporting irregular or incorrect data, pointing to a J1939 CAN bus communication issue between the engine ECU and the controlling device. On EMR4 ECUs, blink code 223 indicates erratic, intermittent, or incorrect data from the charge air pressure sensor located in the intake manifold.

Applies to these machines

  • JLG 800S HC3
  • JLG 860SJ HC3
  • JLG 1200SJP
  • JLG 1350SJP
  • AUSA Equipment

Check the cause

  1. (TSC1 Cause) Check for other active CAN bus or communication-related fault codes, such as timeout errors

  2. (TSC1 Cause) Inspect CAN bus wiring and connectors for chafing, corrosion, pinched wires, or loose connections

  3. (TSC1 Cause) Check CAN bus terminating resistors with power off (should read approximately 60 Ohms between CAN High and Low)

  4. (TSC1 Cause) Measure CAN bus voltages with power on (CAN High should be 2.5-3.0V, CAN Low should be 2.0-2.5V)

  5. (TSC1 Cause) Assess CAN bus load using a diagnostic analyzer (should be below 60%)

  6. (TSC1 Cause) Verify the controlling device is configured with the correct source address expected by the Deutz ECU

  7. (Charge Air Pressure Cause) Inspect the charge air pressure sensor, electrical connector, and wiring for damage, corrosion, or a loose fit

  8. (Charge Air Pressure Cause) Monitor the sensor signal with a diagnostic tool while running to ensure readings change plausibly with engine load and speed

  9. (Charge Air Pressure Cause) Check for air leaks in the intake system between the turbocharger and the engine

Repair steps

  1. Address active CAN faults

    (TSC1 Cause) If other CAN bus or communication faults are present, diagnose and repair them first before proceeding.

  2. Repair CAN wiring

    (TSC1 Cause) Repair or replace faulty CAN bus wiring or termination resistors. Ensure all connectors are clean, secure, and free of corrosion.

  3. Isolate faulty CAN node

    (TSC1 Cause) Disconnect other ECUs from the CAN bus one at a time to see if the fault clears, which helps isolate any node flooding the bus with erroneous messages.

  4. Update controlling device

    (TSC1 Cause) Verify the controlling device (e.g., transmission ECU, display) has the correct software and configuration. Apply manufacturer software updates if available.

  5. Replace charge air pressure sensor

    (Charge Air Pressure Cause) If diagnosing an EMR4 ECU and the sensor signal is erratic or fixed, replace the charge air pressure sensor.

  6. Clear codes and re-test

    Clear all fault codes using a diagnostic tool and operate the machine to duplicate the original complaint, verifying the repair was successful.

Parts you might need

(4)

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes