Deutz-Fahr 232 – EMR3: Speed Above Target Range, Signal Missing or Implausible
Issue description
The EMR3 engine control unit has detected an issue with the signal from the Vehicle Speed Sensor (VSS). The system has detected that the speed is above the target range, or the signal related to speed is missing or not plausible. This indicates an issue with the component responsible for monitoring or controlling speed, which can lead to erratic gear shifting and loss of cruise control.
Applies to these machines
6 machines- Agrotron
- M600 Agrotron
- TCD 2012
- TCD 2013
- TCD 2015
- Genie
Check the cause
Check for other active fault codes using a diagnostic tool. Address battery voltage (SPN 168) or CAN bus communication (SPN 625) faults first, as they can cause erroneous speed sensor codes
Visually inspect the wiring and connectors leading to the vehicle speed sensor for damaged, frayed, or broken wires
Check the sensor's electrical connector for corrosion, bent, or loose pins
Measure the resistance across the sensor terminals with a multimeter (an open circuit or zero resistance indicates a faulty sensor)
For Hall effect sensors, perform a voltage drop test on the circuit to ensure proper voltage levels from the ECU
Test the signal output by lifting a drive wheel, spinning it by hand, and observing for a voltage or frequency increase using a multimeter or oscilloscope
Repair steps
Locate the Vehicle Speed Sensor (VSS)
Find the VSS on the transmission housing, drive axle housing, or near the PTO output shaft.
Remove the faulty sensor
Disconnect the negative battery terminal. Unplug the electrical connector, remove the single retaining bolt, and carefully pull or pry the sensor out of its housing. Be prepared for a small amount of transmission fluid to leak.
Install the new sensor
Clean the mounting surface and ensure the new sensor includes a new O-ring to prevent leaks. Insert the sensor and tighten the hold-down bolt to the manufacturer's specified torque.
Reconnect and clear codes
Reconnect the electrical harness to the sensor and reconnect the battery. Use a diagnostic tool to clear the fault code from the ECU memory.
Test drive
Perform a test drive to verify that the speedometer is functioning correctly, shifting is smooth, and the fault code does not reappear.
Parts you might need
(7)- Vehicle Speed Sensor (VSS)01182834
Genuine OEM Deutz Speed Sensor
Vehicle Speed Sensor (VSS)
01319347Referenced as a speed sensor for Deutz
- Vehicle Speed Sensor (VSS)01182850
Fits various Deutz engine series including 1011 and 2011
- Vehicle Speed Sensor (VSS)04364426
Cross-referenced speed sensor
- Vehicle Speed Sensor (VSS)04438436
125mm speed sensor for some Deutz-Fahr and SAME tractors
- Vehicle Speed Sensor (VSS)04438449
Listed in ZF transmission service document for SAME Deutz-Fahr
- Vehicle Speed Sensor (VSS)04438438
Listed in ZF transmission service document for SAME Deutz-Fahr
Get help to fix this fault by requesting a quote