2634

Deutz-Fahr 2634 – EMR3: Short Circuit to Ground in Relay 1

Issue description

The engine's electronic control unit has detected that the current measured at main relay 1 is above the expected range, indicating a short circuit to the positive battery voltage (Ubatt). This condition can lead to malfunctions in the electrical system. The system will trigger a warning, and the error lamp will show a permanent light. This fault is not self-healing and will remain active until the issue is resolved and the ECU is reset.

Applies to these machines

  • 2012
  • 2013
  • TCD 3.6
  • TCD 4.1
  • TCD 6.1
  • TCD 7.8

Check the cause

  1. Visually inspect the wiring harness connected to the main relay for chafed, melted, or broken wires making contact with the engine block or chassis ground.

  2. Check for poorly executed previous repairs on the harness, such as damaged butt connectors.

  3. Use a multimeter to test for continuity to ground on the power supply wire to the relay to identify cable breaks or short circuits.

  4. Inspect the main relay itself for visible damage, such as a cracked casing or burnt terminals.

Repair steps

  1. Disconnect power

    Ensure the vehicle's battery is disconnected to prevent electrical shorts during the repair.

  2. Locate and remove main relay

    Identify the main relay based on the vehicle's service manual. It is typically located in a fuse and relay box in the engine compartment. Remove the relay from its socket.

  3. Test relay circuit

    With the relay removed and the ignition on, test the terminals in the relay socket. The wire supplying power to the relay coil should have battery voltage. If this wire shows continuity to ground, a short exists in the harness between the fuse/ECU and the relay socket.

  4. Repair wiring

    If a short is found in the wiring, trace the affected wire and repair it with a new piece of wire using properly crimped and sealed connectors. Ensure all connections are secure and insulated.

  5. Test the relay

    Apply 12V and a ground to the coil terminals (typically 85 and 86) and check for continuity between the switch terminals (typically 30 and 87). If the relay clicks and continuity is established, it is likely functional.

  6. Replace the relay

    If the wiring is confirmed to be intact and the fault persists, replace the relay with a new, compatible part. Consider upgrading to a more robust 75-amp dual-circuit relay if the original is underrated.

  7. Reconnect and reset ECU

    Reconnect the battery. Reset the ECU by switching the ignition off, waiting approximately 10 seconds for the main relay to click off, and then switching the ignition back on. Clear any stored fault codes and verify that fault 2634 does not reappear.

Parts you might need

(7)
  • OEM part (also listed as M4216031 or 4216031). Compatible with Deutz 2012, 2013, TCD 3.6, TCD 4.1, TCD 6.1, and TCD 7.8 engines.

  • Deutz Main Relay

    04216032

    OEM part (also listed as 4216032).

  • Upgraded Main Relay

    0 332 002 150

    Bosch 75-amp dual-circuit relay recommended by technicians as a more robust aftermarket replacement.

  • Main Relay4219245

    Verify correct part for specific tractor model and serial number.

  • Main Relay4216031

    Verify correct part for specific tractor model and serial number.

  • Main Relay4219374

    Verify correct part for specific tractor model and serial number.

  • Main Relay

    0421-3435

    Verify correct part for specific tractor model and serial number.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes