2791

Deutz-Fahr 2791 – ECU: Cable break or short circuit

Issue description

The Engine Control Module (ECU) has detected a malfunction within the Exhaust Gas Recirculation (EGR) system, specifically related to the EGR valve and its actuator. While the base description is 'Cable break or short circuit', this code acts as a general identifier for abnormalities in the EGR actuator's operation or communication. This can lead to improper operation or failure of the EGR system, caused by either electrical circuit issues, mechanical binding from carbon buildup, or position deviation errors.

Applies to these machines

  • 5 Series
  • 5C Series
  • 5 TTV Series
  • TCD 2.2
  • TCD 2.9 L4
  • TCD 3.6 L4
  • TCD 4.1 L4
  • TCD 6.1 L6
  • TCD 7.8 L6
  • TCD 2012
  • TCD 2013

Check the cause

  1. Scan for all active and inactive fault codes using a diagnostic tool (like Deutz SerDia), paying close attention to the accompanying FMI code to narrow down the root cause

  2. Check the vehicle's battery voltage to ensure it is within specifications, as low voltage can trigger electrical faults

  3. Thoroughly inspect the wiring harness and connectors leading to the EGR valve and actuator for chafing, corrosion, or loose pins

  4. Visually inspect the EGR valve and its passages for excessive carbon buildup

  5. Manually check if the EGR valve moves freely from stop to stop to check for mechanical restrictions

  6. With the ignition on and engine off, measure voltage between the power and ground pins at the EGR actuator connector (expect >11 volts)

  7. With the ignition off and component disconnected, check for continuity in the wiring harness and for any short circuits to ground or other wires

Repair steps

  1. Repair wiring

    If electrical tests reveal a cable break or short circuit, repair or replace the damaged section of the wiring harness. Ensure all connectors are clean and secure.

  2. Clean EGR valve

    If carbon buildup is causing the valve to stick or bind (often indicated by FMI 7 or 12), remove the EGR valve and thoroughly clean it and the associated passages.

  3. Test EGR actuator

    Using a diagnostic tool like Deutz SerDia, perform an EGR actuator test to command the valve to open and close. Observe its operation to confirm it is functioning correctly. Perform an EGR actuator reset if supported.

  4. Replace faulty component

    If the EGR valve, actuator, or position sensor is determined to be faulty and cannot be repaired by cleaning, replace the component.

  5. Reset the ECU

    Clear the fault codes from the ECU's memory by switching the ignition off, waiting for the ECU to completely shut down, and then switching the ignition back on.

  6. Verify repair

    Start the engine and perform a test drive under various operating conditions to ensure the fault code does not reappear.

Parts you might need

(3)
  • EGR Valve / EGR Actuator

    04120412

    Fits Deutz TCD 2.9 L4 and TCD 3.6 L4 engines. May also be listed as D4120412 or control valve 04120012.

  • Fits Deutz-Fahr 5C, 5 TTV, and 5 Series (Tier 4i) with TCD 2.9/3.6 engines. Interchanges with 4130812. May also be listed as M4134412.

  • Located within the EGR cooler for TCD 2.2 to 7.8 series engines. Replaces 04265310, 04515377, and 04125434.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes