305

Deutz-Fahr 305 – ECU: CAN Reception Timeout TSC 1TE

Issue description

The engine electronic control module (ECU) has detected a communication timeout on the CAN bus network. Specifically, it has stopped receiving the 'Torque/Speed Control 1' (TSC1) message from another control unit, typically the transmission controller. This message is responsible for setpoint assignment, requesting a specific engine speed or torque. The timeout indicates a communication failure originating from the transmitting module, the wiring harness, or the engine ECU itself.

Applies to these machines

  • Agrotron 6 Series
  • Agrotron 7 Series
  • Agrotron 9 Series
  • TD 2.9 L4
  • TCD 2013 Series
  • TCD 2021 Series

Check the cause

  1. Perform a visual inspection of the CAN bus wiring harness between the engine ECU and the transmission control unit for chafing, corrosion, pinched wires, or loose connections.

  2. Check for other active fault codes (U-codes) in all vehicle control modules to identify widespread network problems.

  3. Perform a CAN bus resistance check with power off and battery disconnected (should be approximately 60 Ohms; 120 Ohms indicates a missing termination resistor, while significantly lower indicates a short).

  4. Perform a CAN bus voltage check with ignition on and engine off (CAN High should be 2.5-3.5V, CAN Low should be 1.5-2.5V).

  5. Attempt to isolate the faulty module by disconnecting modules from the CAN bus one at a time, starting with the transmission controller.

Repair steps

  1. Repair wiring and connectors

    If damage is found during visual inspection, repair or replace the affected sections of the CAN bus wiring harness. Clean corroded connectors with electrical contact cleaner and ensure they are securely fastened.

  2. Address termination resistors

    If resistance measurements were incorrect, locate and inspect the 120-Ohm termination resistors at each end of the main CAN bus backbone. Replace any faulty or missing resistors.

  3. Check power and ground

    Verify that both the engine ECU and the transmitting control unit have a stable power supply and a clean ground connection to rule out module malfunction due to poor power.

  4. Update control module software

    Check with a Deutz-Fahr dealer for any available software updates for the engine ECU or other relevant control modules.

  5. Replace faulty control module

    If all diagnostic steps have been exhausted and the evidence points to a specific control module being faulty, replace the transmitting module or the engine ECU.

Parts you might need

(7)
  • CAN Bus Wiring Harness

    Part numbers are specific to the tractor model and configuration

  • Termination Resistor

    Generic 120-Ohm resistor

  • Engine Control Unit (ECU)

    e.g., Deutz EMR4; part numbers are highly specific to the engine and vehicle model

  • Transmission Control Unit (TCU)

    Part numbers are specific to the transmission and vehicle model

  • Transmission Control Unit (TCU/TCM)

    0.012.5955.4

    Example part number only. Verify exact part with VIN.

  • Example part number only. Verify exact part with VIN.

  • Example part number only. Verify exact part with VIN.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes