Deutz-Fahr 391 – ECU: Engine Overspeed During Push Operation
Issue description
The engine's rotational speed has exceeded the predetermined safe warning threshold during a 'push operation' (overrun mode). This occurs when the vehicle's momentum drives the engine rather than the engine driving the wheels, such as during rapid reversing or operating on steep gradients with a heavy load. The Engine Control Unit (ECU) logs this fault to protect the engine from catastrophic damage and may trigger a limp mode. This condition may indicate an issue with the engine's control or performance under load, or it can be operator-induced.
Applies to these machines
6 machines- Agrotron 90
- Agrotron 120
- Agrotron 130
- Agrotron 150
- Agrotron 150.7
- Agrotron 165.7
Check the cause
Question the operator to determine if the fault appeared during high-speed travel, operation on a steep downhill grade, or during a rapid forward-reverse direction change (indicates operator-induced overrun)
Use a diagnostic scanner to check for any other active or logged fault codes related to the transmission, throttle position sensor, or other speed sensors
Thoroughly inspect the wiring harnesses and connectors for the crankshaft and camshaft position sensors for signs of damage, corrosion, or loose connections
Repair steps
Verify sensor signals
Using a diagnostic tool like Deutz SerDia, monitor the live data from the crankshaft and camshaft position sensors. Check for erratic or implausible signals, as an incorrect signal from a faulty sensor can falsely trigger an overspeed code.
Inspect speed sensors
If sensor signals are suspect, remove and inspect both the crankshaft and camshaft speed sensors for physical damage or metallic debris on the magnetic tip. Check the air gap between the sensor and the sensor wheel (reluctor ring).
Test sensor and circuit integrity
Disconnect the sensor and measure its internal resistance to ensure it is within the manufacturer's specifications. Check the wiring harness for continuity, shorts to power, or shorts to ground between the ECU and the sensor connectors.
Inspect sensor wheels
Examine the crankshaft and camshaft sensor wheels for damage, such as bent or missing teeth, or incorrect installation/alignment. A phase shift between the two signals due to misalignment will trigger faults.
Investigate mechanical drivetrain issues
If sensor systems are functioning correctly, investigate the transmission for slipping clutches or a faulty torque converter that could cause the engine to become unloaded and over-rev.
Examine ECU
As a final step, if all other components are verified to be in good working order, the issue could be an internal failure of the Engine Control Unit (ECU).
Parts you might need
(4)Listed for Deutz 2012 and 2013 series engines. Also referenced as 4199447.
- Speed Sensor4210197
For Deutz TCD 3.6 L4, TCD 7.8 L6, and other engines. Cross-reference part number: 4213840.
- Speed Sensor01182850
Listed as a speed sensor for various Deutz diesel engines.
Crank Sensor
04203060Listed as a crank sensor for Deutz engines.
Get help to fix this fault by requesting a quote