473

Deutz-Fahr 473 – ECU: Fuel Pressure Sensor Signal Low

Issue description

The Engine Control Unit (ECU) is receiving a voltage from the fuel pressure sensor that is below the expected minimum threshold. This indicates a potential electrical issue such as a short to ground, an open circuit in the wiring, or a failure of the sensor itself. The ECU relies on this sensor to monitor the fuel pressure in the common rail, which is critical for proper fuel injection timing and engine performance.

Applies to these machines

  • Agrotron K
  • Agrotron M
  • Agrotron TTV
  • Agrotron X
  • TD2.9L4
  • TCD6.1L6
  • TCD2012
  • TCD2013
  • TCD3.6L4

Check the cause

  1. Visually inspect the fuel pressure sensor, its electrical connector, and the wiring harness for any signs of physical damage, corrosion, or loose connections

  2. Use a diagnostic tool to confirm that fault code 473 is active and to read any other associated codes

  3. Rule out actual low fuel pressure caused by mechanical issues like clogged fuel filters or a weak lift pump

  4. Disconnect the sensor and, with the ignition on, check for a 5-volt reference signal from the ECM to the sensor's connector

  5. Check the continuity of the ground wire between the sensor's connector and a known good ground on the chassis or engine block

  6. With the sensor connected, back-probe the signal wire. A voltage reading near 0V could indicate a short to ground, while a reading of 0V on a running engine could point to an open circuit or a failed sensor

Repair steps

  1. Relieve fuel system pressure

    Before working on any part of the high-pressure fuel system, it is crucial to relieve the pressure to avoid injury.

  2. Disconnect the sensor

    Disconnect the electrical connector from the fuel pressure sensor.

  3. Remove the old sensor

    Using the appropriate wrench, carefully unscrew and remove the old sensor from the fuel rail. Be prepared for some minor fuel spillage.

  4. Install the new sensor

    Thread the new sensor into the fuel rail and tighten it to the manufacturer's specified torque.

  5. Reconnect and clear codes

    Reconnect the electrical connector. Use a diagnostic tool to clear the fault code from the ECM.

  6. Prime the fuel system and test

    Prime the fuel system to remove any air that may have entered. Start the engine and check for any leaks. Allow the engine to run and use the diagnostic tool to monitor the fuel pressure readings to ensure the new sensor is functioning correctly.

Parts you might need

(4)
  • Manufactured by Bosch. Includes pressure relief valve and high-pressure sensor. Fits Deutz engines TD2.9L4, TCD6.1L6, TCD2012L42V, TCD2013L62V, and TCD3.6L4.

  • Fuel Pressure Sensor

    QTP-55181

    Fits Deutz Agrotron K COM3, M, TTV, and X Series Tractors.

  • Replaces 4213842. Fits a wide range of Deutz TCD engines including TCD2012 and TCD2013 models.

  • Manufactured by Bosch. May cross-reference with 04194078. Verify correct part number for your specific engine serial number.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes