488

Deutz-Fahr 488 – EMR4: Exhaust Temperature Before SCR-CAT Exceeds Maximum

Issue description

Fault code 488 (SPN 523619, FMI 2) indicates that the engine control unit has registered that the exhaust gas temperature measured by the sensor located upstream of the Selective Catalytic Reduction (SCR) catalyst has surpassed its maximum plausible limit (Physical range check high). This condition may indicate a malfunction with the sensor or its wiring, or an actual engine operation issue such as poor combustion or exhaust leaks causing excessively high exhaust temperatures.

Applies to these machines

  • TD 2.9 L4
  • TCD 2.9 L4
  • TCD 3.6 L4
  • TCD 4.1 L4
  • TCD 6.1 L6
  • TCD 7.8 L6

Check the cause

  1. Check for other active or stored fault codes related to fuel injectors, the turbocharger, or the EGR system, which can cause abnormally high exhaust temperatures.

  2. Visually inspect the exhaust gas temperature sensor (upstream of SCR) and its wiring harness for physical damage, corrosion on connector pins, loose connections, chafing, or heat damage.

  3. Verify sensor plausibility using a diagnostic tool by comparing live data from the upstream SCR sensor with other exhaust temperature sensors and ambient temperature on a cold engine.

  4. Perform electrical testing by disconnecting the sensor and measuring for a 5-volt reference voltage at the harness connector with the ignition on.

  5. Test the sensor's internal resistance for open or short circuits, and optionally heat the sensor with a heat gun to observe if the resistance changes smoothly.

  6. If the sensor and wiring are functioning correctly, inspect for upstream mechanical issues such as exhaust leaks between the engine and SCR catalyst, malfunctioning fuel injectors, air system restrictions (air filter or turbocharger), or DEF system issues (such as a clogged injector).

Repair steps

  1. Cool exhaust system

    Allow the exhaust system to cool down completely before starting any work to prevent burns.

  2. Repair wiring

    If diagnostic checks revealed a wiring issue (chafing, breaks, or heat damage), repair the harness as necessary.

  3. Remove faulty sensor

    If the sensor is determined to be faulty, disconnect the electrical connector. Apply penetrating oil to the sensor's threads and allow it to soak, then carefully unscrew the old sensor using an appropriate wrench or specialized sensor socket.

  4. Prepare new sensor

    Apply a small amount of anti-seize compound to the threads of the new sensor, ensuring none gets on the sensing element.

  5. Install new sensor

    Install the new sensor into the exhaust pipe and tighten it to the manufacturer's specified torque. Reconnect the electrical connector.

  6. Clear codes and test

    Use a diagnostic tool to clear all related fault codes. Start the engine, monitor live data from the new sensor for plausible readings, and perform a road test or operate under load to confirm the fault does not return.

Parts you might need

(4)
  • Listed as EGT and DPF exhaust temperature sensor. Verify fitment by serial number.

  • Original Deutz exhaust gas temperature sensor / temperature transmitter. Fits TCD 2.9, 3.6, 4.1, 6.1, and 7.8 series; sometimes categorized as a coolant sensor. Verify fitment by serial number.

  • Exhaust Gas Temperature Sensor

    0446-7201

    Verify fitment by serial number.

  • Exhaust Gas Temperature Sensor

    0446-7202

    Verify fitment by serial number.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes