511

Deutz-Fahr 511 – ECU: HCI Metering Valve Pressure Too Low

Issue description

The fuel pressure measured by the sensor located after the Hydrocarbon Injection (HCI) post-injection metering valve (DV 1) has fallen below the minimum required threshold. This indicates that an inadequate amount of fuel is being supplied to the exhaust stream ahead of the Diesel Oxidation Catalyst (DOC), which prevents the exothermic reaction needed to burn off soot. As a result, the system triggers an immediate shutdown of the Diesel Particulate Filter (DPF) regeneration process.

Applies to these machines

  • Deutz-Fahr tractors

Check the cause

  1. Verify the fault code is active or has a high occurrence count using a diagnostic tool compatible with Deutz engines (e.g., Deutz SerDia).

  2. Inspect the HCI system fuel supply line (from the main tank or return line) for kinks, blockages, or visible leaks that could restrict fuel flow.

  3. Check primary and secondary fuel filters for clogs, which can reduce overall fuel pressure to the HCI system.

  4. Inspect electrical connectors and wiring for the HCI metering valve (DV 1) and the downstream fuel pressure sensor for signs of corrosion, damage, or loose connections.

  5. Monitor live data for the fuel pressure sensor after the burner post-injection metering valve using a diagnostic tool. Readings should be stable and within spec when commanded on; erratic or zero readings indicate a sensor issue.

  6. Perform an actuation test of the HCI dosing valve using a diagnostic tool. Listen for the valve clicking to verify it is responding to electrical commands.

Repair steps

  1. Resolve fuel supply issues

    If blockages, leaks, or clogged filters were found, clear the blockages, replace damaged lines, and install new fuel filters. Clear the fault codes and attempt a stationary DPF regeneration to see if the fault returns.

  2. Replace fuel pressure sensor

    If live data testing showed erratic or zero pressure readings, replace the fuel pressure sensor located on the fuel line immediately after the HCI metering valve.

  3. Replace HCI metering valve

    If the metering valve (DV 1) failed the actuation test or is confirmed to be the cause of the low pressure, replace the dosing module/metering unit.

  4. Verify repair

    After replacing any components, clear the fault codes from the ECU and perform a service regeneration of the DPF to verify that the HCI system is functioning correctly.

Parts you might need

(4)
  • HCI Metering Valve / Dosing Unit

    M4272612

    Deutz Metering Unit. Direct applicability unconfirmed; verify exact OEM part number with a dealer using the tractor's serial number.

  • Valve001591223

    Exists but without a specific description linking it to the HCI system.

  • HCI Fuel Pressure Sensor

    Specific pressure sensor designed to read fuel pressure in the aftertreatment system.

  • Fuel Filter

    Always use genuine Deutz-Fahr filters to ensure proper filtration and fuel flow.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes