Deutz-Fahr 523222 – EMR3: Speedo Signal Missing
Issue description
The Engine Control Unit (ECU) is not receiving the 'TCO1' CAN bus message, which is responsible for transmitting the vehicle's speed information. This communication breakdown indicates that the signal from the speed sensor is not reaching the engine controller, pointing to a potential issue with the sensor itself, the connecting wiring, or the CAN bus network.
Applies to these machines
23 machines- Agrotron 100
- Agrotron 105
- Agrotron 110
- Agrotron 120
- Agrotron 130
- Agrotron 135
- Agrotron 150
- Agrotron 165.7
- Agrotron 180.7
- Agrotron 230
- Agrotron 260
- Agrotron K
- Agrotron K90
- Agrotron K100
- Agrotron K110
- Agrotron K120
- Agrotron MK3
- Agrotron TTV
- Agrofarm 410
- Agrofarm 420
- Agrofarm 430
- Agrofarm Profiline
- Agrofarm TTV
Check the cause
Visually inspect the wiring harness leading to the speed sensor (typically located on the transmission housing) for cuts, abrasions, snagged cords, or corrosion
Check the continuity of the wires between the speed sensor and the EMR3 ECU to rule out a short circuit or a break in the wire
Inspect the electrical connectors at both the speed sensor and the ECU to ensure they are clean, secure, and free of corrosion
Reset the ECU by switching the ignition off, waiting for the ECU to completely shut down, and then switching the ignition back on to see if the error persists
Inspect the speed sensor component itself for any obvious physical damage
Repair steps
Disconnect power
Always disconnect the battery before starting any electrical repairs to ensure safety.
Repair wiring harness
If a broken wire or damaged connector was found during the diagnostic checks, repair or replace the affected section of the harness. Ensure all connections are secure and weatherproof.
Replace speed sensor
If the wiring is intact and the sensor is faulty, locate the speed sensor on the transmission. Disconnect the electrical connector, unscrew and remove the old sensor, clean the mounting surface, and install the new sensor tightened to the manufacturer's specified torque. Reconnect the plug.
Clear codes and verify
Reconnect the battery. Start the tractor and use a diagnostic tool to clear the fault code from the ECU's memory. Verify that the fault code does not reappear and that the speedometer is functioning correctly.
Parts you might need
(5)- Speed Sensor01182834
OEM Deutz part. Suitable for Agrofarm COM3 series (410, 420, 430), Agrotron K series, and various Agrotron New/Profiline models.
- Speed Sensor0.900.0923.0
Alternate part number.
- Speed Sensor04364426
Alternate part number.
- Speed Sensor2.7099.999.0
Alternate part number.
- Speed Sensor1182850
Alternate part number.
Get help to fix this fault by requesting a quote