564

Deutz-Fahr 564 – ECM: Missing Injector 6 Correction Value

Issue description

The engine control module (ECM) has not been programmed with, or has lost, the specific calibration data (IMA/IQA code) for the fuel injector in cylinder number six. Without this unique correction value, the ECM operates on a default baseline, which can lead to suboptimal engine performance and slight fuel imbalances.

Applies to these machines

  • Deutz engines 4L to 16L with EDC17CV5x
  • Deutz TCD 4.1 L4
  • Deutz TCD 6.1 L6
  • Deutz-Fahr tractors
  • Bomag equipment

Check the cause

  1. Verify the fault code is active using a compatible diagnostic tool such as Deutz SerDia.

  2. Check if the injector for cylinder 6 or the ECM was recently replaced, as this fault commonly occurs if the coding procedure was missed during repair.

  3. Visually inspect the injector for cylinder 6 to locate the alphanumeric IMA/IQA code on the injector body and ensure it is legible.

  4. Evaluate engine symptoms: if severe rough idle, increased smoke, or poor fuel economy are present, the injector itself may be faulty rather than just missing its calibration code.

Repair steps

  1. Connect diagnostic tool

    Connect the Deutz SerDia diagnostic tool to the machine's diagnostic port and turn the ignition on to establish communication with the engine ECU.

  2. Navigate to injector coding

    In the diagnostic software, navigate to the service or calibration menu and select 'Injector Trim Codes', 'Injector Calibration', or 'IMA-Code'.

  3. Select cylinder 6

    Select cylinder 6 for programming. Note that on Deutz engines, cylinder numbering typically starts from the flywheel side.

  4. Enter correction code

    Carefully enter the alphanumeric IMA code exactly as it is printed on the body of the injector for cylinder 6.

  5. Program and verify

    Store the new value into the ECM. Cycle the ignition off, wait at least 10 seconds for the ECU to store the value, then turn the ignition back on. Re-read the values to verify the code was successfully saved.

  6. Clear fault codes

    Clear all active and inactive fault codes from the ECM.

  7. Test operation

    Start the engine and let it idle to confirm smooth operation. Perform a test drive to allow the ECU to complete its adaptation process with the new injector data.

  8. Replace injector (if necessary)

    If the IMA code is illegible or the injector is determined to be mechanically faulty, replace the injector with a new or remanufactured unit and perform the coding procedure with the new IMA code.

Parts you might need

(3)
  • Common Rail Fuel Injector (Deutz 2012/2013 Series)

    04290986

    Alternative part number 04290987. Verify exact fitment by engine model and serial number.

  • Alternative part number 2112957. Verify exact fitment by engine model and serial number.

  • Common Rail Fuel Injector (Deutz TCD 3.6 L4)

    04123831

    Verify exact fitment by engine model and serial number.

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes