654

Deutz-Fahr 654 – ECU: Early Opening Defect of Main Relay

Issue description

The Engine Control Unit (ECU) has detected that the main power relay, which supplies power to the engine control system, has opened sooner than expected after the ignition is switched off. This prevents the proper shutdown sequence for the ECU and may cause unexpected shutdown or failure of the electrical system. In some systems, this fault may also indicate a short circuit to ground or an emergency shut-off condition.

Applies to these machines

  • TCD 2012
  • TCD 2013
  • TCD 3.6
  • TCD 4.1
  • TCD 6.1
  • TCD 7.8

Check the cause

  1. Inspect Battery and Connections: Ensure the battery is fully charged and that all battery terminals and ground connections are clean, tight, and free of corrosion.

  2. Check Fuses: Inspect all fuses related to the engine control system.

  3. Inspect Wiring Harness: Visually inspect the wiring harness for the main relay and the ECU for signs of damage, such as chafing, breaks, or corrosion on the connector pins, as well as poor connections in butt connectors or improperly sized wires.

  4. Relay Click Test: With the ignition off, have someone listen near the fuse box while you turn the key to the 'on' position to hear a distinct click.

  5. Relay Swapping (if applicable): If the main relay is external and identical to other relays in the fuse box, swap it with a known good relay from a non-critical circuit.

Repair steps

  1. Disconnect Power (External Relay Systems)

    Disconnect the battery before beginning any electrical repairs.

  2. Locate and Remove the Main Relay (External Relay Systems)

    Find the main relay, typically located in the main fuse and relay box, and remove it.

  3. Test the Relay (External Relay Systems)

    Using a multimeter, check for continuity between control circuit pins (85 and 86); it should show 50-200 ohms (OL indicates a broken coil). Apply 12V to pins 85 and 86 to verify an audible click. While energized, check continuity between load circuit pins (30 and 87) for very low resistance (close to 0 ohms).

  4. Check Wiring and Connectors (External Relay Systems)

    If the relay tests good, thoroughly check the wiring and connectors between the relay socket and the ECU for damage, corrosion, or loose connections. Repair or replace wiring as necessary.

  5. Replace the Relay (External Relay Systems)

    If the relay is found to be defective during testing, replace it with a new one.

  6. Reconnect and Test (External Relay Systems)

    Reconnect the battery and turn the ignition on. Clear any fault codes using a diagnostic tool and verify that the fault does not return.

  7. Perform Diagnostic Checks (Internal Relay Systems)

    For systems with an internal main relay (e.g., EMR3-E / EDC7), thoroughly execute all diagnostic checks on the wiring leading to the ECU.

  8. ECU Replacement (Internal Relay Systems)

    If the fault persists after verifying the wiring and it is determined to be internal to the ECU, the ECU itself may need to be replaced as a last resort.

Parts you might need

(5)
  • Main Relay04216031

    Deutz OEM part (listed for TCD 2012, 2013, 3.6, 4.1, 6.1, and 7.8 engines)

  • Main Relay4216032

    Deutz OEM part

  • Main Relay4219374

    Deutz OEM part

  • Main Relay01340791

    Deutz OEM part

  • Main Relay

    0 332 002 150

    Bosch aftermarket/alternative relay

Get help to fix this fault by requesting a quote

Browse other Deutz-Fahr codes