Deutz-Fahr 888 – ECU: Current Engine Torque Data Irregular
Issue description
The Engine Control Unit (ECU) has detected an irregularity in the data used to calculate the current percentage of engine torque (J1939 equivalent SPN 513, FMI 2). Because actual engine torque is a calculated value rather than a direct measurement from a single sensor, this indicates that one or more sensor inputs (such as engine speed, fuel pressure, or air intake) are providing erratic, intermittent, or incorrect signals. This discrepancy can negatively affect the proper operation of the tractor's performance monitoring and control systems.
Applies to these machines
3 machines- Agrotron
- Genie lifts (Deutz TD 2.2L)
- Genie lifts (Deutz TD 2.9L)
Check the cause
Check battery and system voltage to ensure the alternator is functioning correctly, as low or unstable voltage can cause erratic sensor behavior.
Visually inspect the main engine wiring harness and sensor connectors (especially fuel and air intake) for chafing, heat damage, corrosion, or loose pins.
Perform a full ECU reset after any inspection or repair by switching the ignition off and waiting for the main relay to click off (usually 30-60 seconds) before switching it back on.
Monitor Engine Speed Sensors (Crankshaft and Camshaft) for consistent RPM readings without dropouts.
Check Fuel System Sensors (Fuel Rail Pressure and Fuel Metering/Quantity Actuators) for unstable or illogical readings.
Inspect Air Intake System Sensors (Boost Pressure, Intake Air Temperature/Pressure) for plausible values corresponding to current engine load.
Verify the Accelerator Pedal/Lever Position Sensor provides a smooth and linear signal as it is depressed and released.
Repair steps
Connect diagnostic tool
Connect Deutz SerDia or a compatible diagnostic tool to confirm the active SPN 513, FMI 2 fault and monitor live engine data.
Inspect and repair wiring
Perform a physical inspection of the engine wiring harness, focusing on the crankshaft sensor, fuel rail pressure sensor, and main ECU connectors. Repair any compromised wiring and clean corroded pins.
Analyze live sensor data
With the engine running, monitor live data streams for speed, fuel, air, and pedal sensors. Identify any signal that is jumping erratically, dropping out, or showing implausible values for the engine's operating state.
Isolate and test faulty circuit
Once an erratic signal is identified (e.g., unstable crankshaft RPM), test the specific sensor's internal resistance according to manufacturer specs. Check its circuit for continuity, shorts to ground, or shorts to power back to the ECU.
Replace faulty components
If a sensor fails testing or its wiring is irreparably damaged, replace it with a genuine OEM part. Note that FMI 2 codes frequently stem from wiring or connector issues rather than the sensor itself.
Clear faults and reset ECU
Clear the fault code using the diagnostic tool. Perform a full ECU reset by switching the ignition off, waiting 30-60 seconds for the main relay to click off, then switching it back on. Operate the machine under load to verify the repair.
Parts you might need
(7)Deutz/Bosch OEM part for various Deutz series (1013, 2012, 2013, TCD)
Deutz/Bosch OEM part for TCD 3.6 L4
Inductive Speed Sensor
60704015Granit brand for various Agrotron models
Engine Speed Sensor
60760073Granit brand for various Agrotron models
Fuel Rail Pressure Sensor
Verify fitment by engine serial number
Boost Pressure Sensor
Verify fitment by engine serial number
Accelerator Pedal Position Sensor
Verify fitment by engine serial number
Get help to fix this fault by requesting a quote